ADEMCO 745x3 Installation guide

Brand: ADEMCO

Model: 745x3

Type: Installation guide

ADEMCO 745x3 is a versatile voice siren driver designed to enhance the security of your premises with customizable alarm messages and a range of features. Here are some key capabilities of the device:

Voice Output: The 745x3 generates voice messages in English, French, and Spanish, providing clear and understandable alerts during emergencies.
Separate Messages: It offers distinct voice messages for fire and burglary conditions, allowing for targeted responses to different types of threats.
Siren Sounds: The device features separate siren sounds for fire and burglary conditions, creating a distinctive audible notification for each scenario.

Voice Output: The 745x3 generates voice messages in English, French, and Spanish, providing clear and understandable alerts during emergencies.
Separate Messages: It offers distinct voice messages for fire and burglary conditions, allowing for targeted responses to different types of threats.
Siren Sounds: The device features separate siren sounds for fire and burglary conditions, creating a distinctive audible notification for each scenario.

N%&&l %92

74!5X3/ VOICE SIREN DRIVER

Features

. Generates voice output in Engbsh, French, and Spanish.

. Separate messages for FIRE and BURGLARY condtions.

. Separate siren sounds Ior FIRE and BURGWRY conditions.

. Terminal sttip for secure connection to wntrol panel.

. %lwQble input level (HigfdLow) for FIRE/BURGURY inputs.

. Supewision feature for s~aker and speker wiring

. Compatible with most conwol panels.

. Sounder options for kll ringbac~ell test.

. Com~tible with &160hm speakers.

, Operates on 12-16V DC.

. Small compact size for easy instillation using double-sidti tip

(packed separately) - measures Only 0 x 2-5/W x 1-1/4”.

Output Selection

The voice dtiwr an be pogrammed for the desired alarm output

on burgla~ and fire by means of jumpers JPI through J~4, as

indicated in Table 1. %e Figure 1for 10=tiOn of jUmPeH.

Table 1. Output Selatlon

X =CUT, —= INTACT

Bell Tes~lngback Options (JP5)

If jumper JP5 is kept intact, the siren diver will generate a steady

sound for bell test and bell tingback rnndtions.

If the jumper is cut, a warbled sound will be generated for bell

tesVtingback conditions. Note: If this mode is selected, a fire

signal will momentarily generate a warbled siren sound for the

initial poflion of the siren sound and then revefl to tie normal siren

sound and voim message.

Burgfaw Signal Polarity (JP6]

Intact = Mgh(i 2V+), mt = Low (OV).

The burglav message may be activated by either a sieady logic

high or a steady logic low, as provided by the control panel (refer

to the antrol pane~s instructions).

When jumper JP6 is intact, activation is by a logic high (12V+) at

terminal 2. Cut jum~r JP6 for activation by a logic low (OV). Note

that a pu/sing Mgh or low (pulse width 0.25 to 1.75 sewnds, that is

provided by some panels) connected to the BurglarylFire input

(terminal 2) will be interpreted as a Fire condition and will produe

the fire message.

Fire Signal Polarity (JP7)

Intact =Wgh(12V+), cut = Low (OV).

As in the case of Burglaw signal Platity, the fire message maybe

activated by either a logic high or logic low, but at terminal 3

(Ademco control panels provih a logic high). When jumper JP7 is

intact, activation is by a logic high (i 2V+). Cut jumper JP7 for

activation by a logic low (OV).

Burgla~ Wles=ges:

ENGLISH:

YOU HAVE VIOLATEO A PROTECTEDAREA . . . THE POLICE

HAVE BEEN CALLEO . . . LEAVE IMMEDIATELY!

SPANISH:

USTEO HA VIOLA~ UNA AREA PROTWIOA . . LA POLICIA H1

sl~ LLAMP,DA . . .

SALGA IMMEOIATMENTE!

FRENCH:

VOUS AV= PENHRE UN LfEU SURVEILLE . . . LA POLICE A

ETEAVERTI . . ~AQUEZ IMMEOIATEMENT!

Burg/a~ A/arm Sequen@:

Warble Siren sound, Burglaw Voim Message (repeated 3 times),

1$semnd Warble Siren %und.

Sequence wtill r@peat until the Burglary output co~?dition is

terminat~.

Fire Messs!ges:

E:’::

]

FUEGO . . . SALGA IMMEOIATEMENTE!

AU FEU! . . . EVAQUEZ IMMEDIATEMEN1!

Steady Shell Sound, Fire Vokce Message repeated 3 times on

single langu?~geoutput, followed by 15 seconds of Steady Siren

Se uence wil~ntil the Fire output condbion is terminated.

Wiring C0!3necti0ns

Witing connections to the terminals are as follows. Refer to Figure

1 (and Table 2 for Abmo prducls).

1 SUPW SF’EAKEWIRING SUPERVISION (OPTIONAL).

For supewision of the speaker and associated widng, connect to a

24-hour zonf that is activated by a shod.

Removing the speaker or shorting either speaker terminal to

ground will ,%ppearas a shorn on the zone. Note that in seties-

mnnected w,ultiple speaker systems, cutting any speaker will tip

the antrol p~nel,s supewision zone. In parallel-mnnetied speaker

systems, each branch must be cut before the control panel’s

supervision 20ne will hip.

2 WE BURGURY/FIRE INPUT:

Connect thc~ control pane~s Burglary (steady) output to this

terminal. Tti:s terminal may also be used to rip the FIRE message

if tie control provihs a pulsing output for fire (re-program[ming may

be requird). In this ase, no connection to terminal 3 is r<?quir~.

3 F: F/RE //VPUT:

Connect the control DaneVsoutDut designated as the FIRE (steady)

vol~ge outptlt to thi; terminal (unless t~s output was cotlnicted to

terminal 2).

4 SPKR& 5 !jPKR: SPEAKER TERMINALS:

Connect an E-ohm or <6-ohm 15-watf speaker to tiese terminals.

See Rgure 3 for multiple speaker configurations.

6 (+} 12VDC(+) POWER /NPUT:

Connect to a

12VDC (+) sour~ on the anwol; sine the dtiver can

draw as muf:h as 1.i imps, it may be necessay in some cases

(see Table 2 for Ademco products) to connect to the system’s

back-up batb?w through a 2 amp in-fine fuse, as shown in Figure 2.

7 (-): 12VDC(-) POWER INPUT:

Corm-l to a gro.”d point (–) on the control pmel.

Speakers: 15-watt s~akers.

Sound Output: 106dB @ 10 ft.

Current Dralm

8-ohm Speakec 1100 mA (steady siren)

(at 12V

Oc) 12@hmSpeakefi 950 mA (steady siren)

)6-ohm Speakec 800 mA (steady siren

fmpotiant: ‘We recommend that the Voice Siren Driver be

mount~ in <hecontrol cabinet, not remotely.

—

[

JP,

SEE dP2

TA~LE dP3

4P.

JP5

VOICE

SIREN

ORIVER

BURG& FIRE

INpuTSIGNAL

,NT:g2yg;~:

$;~:G

SPEAKER

1234567

SUperViSiOn.

CONNECTTO24.HR

20NE ONCONTROL

- 12VDC

TOSUROURYffIRE

AmRM OUTPW

+ TI;LE 2)

ONcONTROL,

‘“’?&%M””-

. IF AMRM OUPUTISSTEADY FOR BURG

AND PULSING FOR FIRE, NO CONNECTION

IS NEEDED AT TERMINAL 3

Figure 1. Siren Driver Board

Figure 2. Connecting Power to the 745X3

4 SP~KERS

8 OHM LOAD

8fi

Figure 3. Typlml Multiple Speaker Configurations

ALARM DEVICE ~NUFACTURING CO.

A DIVISION OF Pl~WAY CORPO~TlON

165 EiI~n Way, Syosset, New Yok 11791

Copy,iQht @ IW2 PI=WAY CORPOMTlON

Table 2. Wiring tinnectlons For Ademco Control Panels’

[

ADEMcO

CONTROL

745X3 TERMINALS

PANEL

1!2

456

Spfm to 4

Rsdw,TT 4

fsad thw

2Aruss 4

(sss Fig.2).

+12V LUG 15

; Spficsb 5

R8d8ATT 5

fsad &w

2A IU2S

(sse Fig.2).

1 I

+ For fu@er information, consult the conwo!pne~s insmctions,

Note: If using the 745X3’witi &control with a built<n siren dtiier,

mnsult that contops instwctions to &twminn the method to disable

the built<n siren diver and e“sble the bell o“tp”t.

LIMITED WAR~N~

Alarm Devics Manufacluting Company, a Division of PittWay

Corporation, and its divisions, subsitiaties and affiliates ~Seller”),

165 Eileen Way, Syosset, New York 11791, warrants its products ~

bs in conformance with its own plans and specifi~lio”s a“d to be

hee kom defects in matetiafs and workmanship under normal use

and sewi~ for 18months from the date stsmp mntrol on the prcduct

or, for products not having sn Ademm date s~mp, for 12 mon:hs

from &te of otiginal purchase unless the instsflation instructions or

mfslog sets fonh a shoner ~tiod, in which csse the shoner petiod

shall apply. Seller%s obligation shall be limited to repairing or

replacing, at its option, free of charge for matetials or labor, any

product which is proved not i“ compfim~ witi ~ltets sp~ifi~tions

or proves &fective in materials or wotimanship under normal use

and sawi~, Seller shall have no obkgation under this Limited

WaTrn~ or orhenvise if the product is altersd or improperly repair8d

or sewiced by anyone other than Ad%mco facto~ sewice. For

warran~ sewic8, return product transpotiation prepaid, to A&mco

Facto~ *M=, 165 Eileen Way, Syoswt, New York 11791.

THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF

MERCHANTABILITY, OR FITNESS FOR A PARTICULAR

PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE

DESCRIPTION ON THE FACE HEREOF. IN NO CASE SHALL

SELLER BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR

INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER

WARRANTY, EXPRESS OR IMPLIED, OR UPON ANY OTHER

BASIS OF LIASILITV WHATSOEVER, EVEN IF THE LOSS OR

DAMAGE IS CAUSED BY THE SELLERS OWN NEGLIGENCE OR

FAULT.

S811erdoes not represent that the products it sells may not be

wmpromised or circumvented; that the products will prevent any

p8rsond injuV or propefly loss by burglary, robkry, fim or othewis8;

or that tie prducts will in all =ses provide ad~uate waning or pro-

tection. Customer utierstands that a properly installed and

mai”mi”ed alarm may O“IY,ed”- tie risk of a buglaV, robb~, fire

or other events occuming without providng an alarm, but it is not

insuranm or a guarante8 that such will not o-r or that them will k

no personal injuV or prop~ loss as a result. CONSEQUENTLY,

SELLER SHALL HAVE NO LIABILITY FOR ANY PERSONAL

INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON

CLAIM T

IF SELLER IS HELD LIABLE, WHETHEi””D;iE;TL~ b;

INDIREcTLY, FOR ANY LOSS OR DAMAGE ARISING UNDER

THIS LIMITED WARRANTY OR OTHERWISE, REGARDLESS OF

CAUSE OR ORIGIN, SELLERS MAXIMUM LIASILITV SHALL NOT

IN ANY CASE EXCEED THE PURCHASE PRICE OF THE

PRODUCT, WHICH SHALL BE THE COMPLETE AND EXCLUSIVE

REMEDY AGAINST SEI

rHE PRODUCT FAILED TO GIVE WARNING.

HOWFVFR

!LLER, This wamanty repfaczs any previous

warmnties and is the only wamanty made by Seller on ths product,

No increase or alteration, written or vebsf, of the obligations of t~~

Limit@ W=ranty is authorized.

N9080–1 5/92

ADEMCO 745x3 Installation guide

Brand: ADEMCO

Model: 745x3

Type: Installation guide

Voice Output: The 745x3 generates voice messages in English, French, and Spanish, providing clear and understandable alerts during emergencies.
Separate Messages: It offers distinct voice messages for fire and burglary conditions, allowing for targeted responses to different types of threats.
Siren Sounds: The device features separate siren sounds for fire and burglary conditions, creating a distinctive audible notification for each scenario.

Download PDF

report

in other languages

italiano: ADEMCO 745x3 Guida d'installazione

ADEMCO 745x3 Installation guide

ADEMCO 745x3 Installation guide

in other languages

Related papers

Other documents