Feiss WB1713 Installation guide

Type
Installation guide

This manual is also suitable for

1
Installation Instructions for
Harrow 1 Light Wall
1.2
WB1713
WB1713
Install the glass panels by sliding them into the fixture and securing them using the tabs.
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
2
2
5
6
FIXTURE SCREW
6
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed fo damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
ALLEN WRENCH
MOUNTING
PLATE SCREW
7
7
GLASS PANEL
1
GLASS PANEL
TAB
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, IL 60077
800.969.3347
www.Feiss.com
© 2015 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Feiss WB1713 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI