INSERTING AN iPod
®
/ MP3 PLAYER
For the iPod and iPod mini:
1. Pull the right and left speakers outward, until fully extended, as shown
in FIGURE 1 below.
2. Rest your iPod / iPod mini on the ledge. Push the speakers back
inward
gently until your iPod / iPod mini fits snugly between them, as
shown in
FIGURE 2 below. Then proceed to the “USING YOUR
iPod
®
/ MP3 / PORTABLE CD PLAYER WITH THIS UNIT” section.
For the iPod nano or iPod shuffle:
1. Follow Step 1 above.
2. Select the proper adapter, following
FIGURE 3 below.
3a.For the iPod shuffle: Insert the shuffle adapter into the main unit by
aligning the pegs at the bottom of the adapter with the holes in the
ledge of the main unit. Once the adapter is secure, insert your iPod
shuffle in the adapter. Then proceed to the “USING YOUR iPod
®
/
MP3 / PORTABLE CD PLAYER WITH THIS UNIT” section.
3b.
For the iPod nano: Plug the
Stereo Audio cable (attached to
the main unit) into the Headphone
jack on your player. Then insert
your iPod nano in the adapter as
shown in
FIGURE 4 (the Stereo
Audio cable’s plug will be resting
on the adapter). Insert the adapter
into the main unit by aligning the
pegs at the bottom of the adapter
with the holes in the ledge of the
main unit, and secure snugly between the speakers. Then proceed to
Step 2 in the “USING YOUR iPod
®
/ MP3 / PORTABLE CD PLAYER
WITH THIS UNIT” section.
For other MP3 players:
Other MP3 players can not rest directly on the ledge of this unit, neither
with nor without an adapter. However, the sound from other MP3 players
can be heard through this unit’s speakers. Follow the instructions in the
“USING YOUR iPod
®
/ MP3 / PORTABLE CD PLAYER WITH THIS
UNIT” section.
USING YOUR iPod
®
/ MP3 / PORTABLE CD PLAYER
WITH THIS UNIT
1. Plug the Stereo Audio cable (attached to the main unit) into the
Headphone jack on your player (as shown in FIGURE 5 in the next
column).
2. With the batteries inserted or the unit operating on AC power (see
“POWER SOURCES” section), slide the POWER switch to ON; the
GENERAL:
Power Source ...............................DC 6V Adapter (Center Positive) or
.....................................4 x “AA” size batteries (max play time 8 hours)
Speakers..............................................................................2 x 4 ohms
Output Power ............................................................................2 x 2W
Dimensions ....................................................5 L x 4.5 W x 2 D inches
Weight ...............................................10.6 oz. (not including batteries)
Specifications are subject to change without notice.
EMERSON RADIO CORP.
LIMITED WARRANTY
Emerson Radio Corp. warrants manufacturing defects in original material,
including original parts and workmanship, under normal use and conditions,
for a period of ninety (90) days from the date of original purchase in the U.S.
With your dated proof of purchase, we will provide repair service at no charge
for labor and parts at an authorized Depot Repair Facility, or replace the
product in our discretion. For repair or replacement, pack your unit in a
padded box, enclose your check or money order payable to Emerson Radio
Corp. in the amount of $9.00 (not required by California residents) to cover
shipping and handling costs, and enclose a copy of your proof of purchase.
Send your unit to:
Emerson Radio Corp.
5101 Statesman Drive
Irving, TX 75063
This warranty does not cover damage from negligence, misuse, abuse,
accident, failure to follow operating instructions, commercial use, rental,
repairs by an unauthorized facility, or products purchased, used, serviced or
damaged outside of the United States.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY
ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
AU898M
The serial number of your system is located on a label on the rear cabinet.
Please take a moment now to locate the serial number and write the number
in the space provided below. You may be asked to provide this number when
calling for product service.
Model Number: SB700
Serial Number:
__________________________________________
SB700–092706–02 Printed in China
FIGURE 1
FIGURE 2
FIGURE 3
iPod nano adapter iPod shuffle adapter
OPERATION
SPECIFICATIONS
WARRANTY
Power indicator will light.
3. Operate the iPod / MP3 player as per its owner’s manual and the
sound will be heard through this unit’s speakers.
4. When done listening, slide the POWER switch to OFF; the Power
indicator will go out. Make sure to also turn off your player.
OPERATION (CONTINUED)
FIGURE 5
FIGURE 4