GNSF35Z

GE GNSF35Z User manual

  • Hello! I am an AI chatbot trained to assist you with the GE GNSF35Z User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the salt capacity of the GE GNSF35Z water softening system?
    What type of warranty does the GE GNSF35Z water softening system come with?
    How often does the GE GNSF35Z water softening system regenerate?
    What is the maximum hardness removal capacity of the GE GNSF35Z water softening system?
    What is the maximum iron reduction capacity of the GE GNSF35Z water softening system?
    What type of resin filter does the GE GNSF35Z water softening system use?
Created 7/98
GE Appliances
GNSF35Z—GE SmartWater
Softening System
Salt Capacity – 200 lbs.
Warranty Information
Full One-Year Warranty –
(parts and labor at no additional charge) applies to entire unit.
Limited Three-Year Warranty –
(parts only) applies to electronic monitor.
Limited Ten-Year Warranty – (parts only)
applies to replacement cabinet (brine tank) or resin tank.
See written warranty, packed with product, for details.
Important: All units must be installed according to local plumbing
and electrical regulations.
48-3/4
41-1/4
Front View
IN-OUT
18-1/4
Dia.
3-3/8
For answers to your Monogram,
®
GE Profile Performance Series,
GE Profile
or GE appliance questions, call
GE Answer Center
®
service, 800.626.2000.
Created 7/98
GE Appliances
MAIN SHUTOFF
VALVE
WATER METER
GROUND
STRAP
SECURED
HARD WATER TO HOUSE
INLET
OUTSIDE FAUCET
(HARD WATER)
OUTSIDE FAUCET
(HARD WATER)
SOFT, COLD
WATER
SOFT, HOT
WATER
BE SURE HARD WATER IS
PLUMBED INTO SOFTENER
VALVE INLET
BE SURE BYPASS VALVE STEM IS
POSITIONED FOR SOFT WATER "SERVICE"
BE SURE VALVE DRAIN HOSE RUNS
DIRECTLY TO AN ACCEPTABLE DRAIN
POINT, AND IS NOT PINCHED, KINKED
OR ELEVATED TOO HIGH IF RUN
OVER- HEAD. DID YOU PROVIDE AN
AIR-GAP AT THE DRAIN POINT?
THE BRINE TANK OVERFLOW
HOSE IS A GRAVITY DRAIN. BE
SURE THE HOSE IS NOT RAISED
HIGHER THAN THE FITTING ON
THE TANK AND IS SECURED
DID YOU FILL THE BRINE TANK WITH
SALT?
BE SURE THE ELECTRIC OR
FUEL SUPPLY TO THE WATER
HEATER IS ON
DID YOU SET THE TIMER TO THE
CORRECT TIME OF DAY, AND
WATER HARDNESS NUMBER?
IS THE TRANSFORMER PLUGGED
INTO A CONTINUOUSLY "LIVE"
120V-60Hz OUTLET?
WATER
SOFTENER
WATER
HEATER
EXTREMELY IMPORTANT
• Install softener at point-of-entry into house before water heater.
Needs to be within five feet of water inlet.
• Install within ten feet of proper drainage; e.g. drain, standpipe
or a sump which does not drain directly to outside.
• Within ten feet of 120V, 60Hz electrical outlet-
transformer must be plugged into an inside outlet.
• All units must be installed according to local plumbing and
electrical regulations.
NOTE: Should not be installed in
direct sunlight, freezing conditions,
or where unit can get wet.
For answers to your Monogram,
®
GE Profile Performance Series,
GE Profile
or GE appliance questions, call
GE Answer Center
®
service, 800.626.2000.
GNSF35Z—GE SmartWater
Softening System
GNSF35Z—GE SmartWater
Softening System
RECHARGE TONIGHT
TOUCH
SELECT
SmartWater
Softening System
HARDNESS
TIME
HOLD
or
RECHARGE NOW
Super 35
Features and Benefits
• Grey / Round
• Electronic-Demand Drive
• GE Simple-to-Set Electronic Controls
• Permanent Settings Memory
• Super Capacity (35,000 grain capacity)
• Demand-Initiated Regeneration
• Efficiency (5168 gpg)
• Maximum Hardness Removal (100 gpg)
• Maximum Iron Reduction (6 ppm)
• Standard Mesh Resin Filter
• 24 Volt Electronic System
• Salt Storage Capacity (200 lbs.)
• Water Used for Regeneration (40-50 gallons)
• Regneration Time (118 minutes)
• Installation Kit, Bypass Valve and Drain Tubing Included
Model GNSF35Z - Grey
GE Appliances
Created 7/98
/