OTC 7497A User manual

Type
User manual

This manual is also suitable for

Rear Axle Bearing Puller
Removes semi-oating rear axle bearings.
For use with slide hammers that have a 5/8" threaded end.
No. 7495A ts minimum bearing tube I.D. of 1
1
/4
" and
maximum axle tube I.D. of 1
7
/8".
No. 7496A ts
minimum bearing
tube I.D. of 1
5
/16" and
maximum
axle tube I.D. of 2
3
/8".
No. 7497A ts
minimum bearing
tube I.D. of 1
3
/8" and
maximum
axle tube I.D. of 2
7
/8".
Operating Instructions
1. Insert tool into axle bore until it grasps behind the bearing.
2. Tighten the nut and washer against the bearing face.
3. Use slide hammer to remove bearing.
Slide Hammer
Martillo de percusión
Extracteur à inertie
Operating Instructions for : No. 7494A
Instrucciones de funcionamiento para : No. 7495A
Consignes d'utilisation pour : No. 7496A
No. 7497A
© SPX
Form No. 107351
Rev. B, June 20, 2008
Rear Axle Bearing Puller
Halador del cojinete del eje trasero
Arrache-roulement d'essieu arrière
  • Page 1 1
  • Page 2 2

OTC 7497A User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages