COBHAM Sailor 6390 Navtex Installation guide

COBHAM
Brand
COBHAM
Model
Sailor 6390 Navtex
Type
Installation guide
Drilling plan
What’s in the box? Dimensions
SAILOR 6390 Navtex Receiver
Installation guide
Fuse
(1 A)
Fuse Puller
SAILOR 6390 Navtex Receiver
Installation Guide
SAILOR 6390 Navtex Receiver
Cable RJ45
5 m
User Manual
SAILOR 6390 Navtex Receiver
SAILOR 6390 Navtex Receiver
User manual
Drilling plan
What’s in the box? Dimensions
SAILOR 6390 Navtex Receiver
Installation guide
Fuse
(1 A)
Fuse Puller
SAILOR 6390 Navtex Receiver
Installation Guide
SAILOR 6390 Navtex Receiver
Cable RJ45
5 m
User Manual
SAILOR 6390 Navtex Receiver
SAILOR 6390 Navtex Receiver
User manual
How to install the Navtex Receiver
What’s in the box? Dimensions
SAILOR 6390 Navtex Receiver
Installation guide
Fuse
(1 A)
Fuse Puller
SAILOR 6390 Navtex Receiver
Installation Guide
SAILOR 6390 Navtex Receiver
Cable RJ45
5 m
User Manual
SAILOR 6390 Navtex Receiver
SAILOR 6390 Navtex Receiver
User manual
How to install the Navtex Receiver
What’s in the box?Dimensions
SAILOR 6390 Navtex Receiver
Installation guide
Fuse
(1 A)
Fuse Puller
SAILOR 6390 Navtex Receiver
Installation Guide
SAILOR 6390 Navtex Receiver
Cable RJ45
5 m
User Manual
SAILOR 6390 Navtex Receiver
S
A
ILO
R
6
39
0
Na
v
te
x
Rec
e
iv
e
r
SAI
LO
R
6
390
Na
v
t
e
x
Re
c
e
i
v
e
r
Screw M4x12
TORX 20
(5 pcs.)
Screw ST3.9x19
TORX
(5 pcs.)
Mounting tool for
terminal blocks
Cable Tie
5x200 mm (8 pcs.)
19
0
mm
270mm
4
2.5
mm
LED overview
1
5
.5 mm
12
4
m
m
50
.
5
mm
12 mm246 mm12 mm
4 x M4 or hole for
self-tapping ø3.8 mm
1
90 mm
270 mm
Disclaimer: Any responsibility or liability for loss or damage in connection with the use of this product and the accompanying documentation is disclaimed by Thrane & Thrane. The information in this manual is provided for information
purposes only, is subject to change without notice and may contain errors or inaccuracies. Manuals issued by Thrane & Thrane are periodically revised and updated. Anyone relying on this information should acquire the most current
version e.g. from cobham.com/satcom or from the distributor. Thrane & Thrane is not responsible for the content or accuracy of any translations or reproductions, in whole or in part, of this manual from any other source. Thrane &
Thrane A/S trading as Cobham SATCOM
Copyright © 2013 Thrane & Thrane A/S. All rights reserved.
Cable recommendation
F
Power: 0.5 mm² +/- PE shielded
F
NMEA: Shielded twisted pair (GPS / INS IN / INS OUT)
F
Alarm: Shielded two wires (e.g. 0.5 mm²)
F
LAN: Cat5e or better, shielded (STP)
190mm
42
.5
mm
Power: Lit when device is on.
Rx: Flashes when receiving navtex data on any
active frequency.
Test: Lit when selftest is passed. Flashes if fault detected.
Screw M4x12
TORX 20
(5 pcs.)
Screw ST3.9x19
TORX
(5 pcs.)
Mounting tool for
terminal blocks
Cable Tie
5x200 mm (8 pcs.)
190mm
270mm
42.5mm
LED overview
15.5 mm
124 m
m
50.5 mm
12 mm 246 mm 12 mm
4 x M4 or hole for
self-tapping ø3.8 mm
190 mm
270 mm
Disclaimer: Any responsibility or liability for loss or damage in connection with the use of this product and the accompanying documentation is disclaimed by Thrane & Thrane. The information in this manual is provided for information
purposes only, is subject to change without notice and may contain errors or inaccuracies. Manuals issued by Thrane & Thrane are periodically revised and updated. Anyone relying on this information should acquire the most current
version e.g. from cobham.com/satcom or from the distributor. Thrane & Thrane is not responsible for the content or accuracy of any translations or reproductions, in whole or in part, of this manual from any other source. Thrane &
Thrane A/S trading as Cobham SATCOM
Copyright © 2013 Thrane & Thrane A/S. All rights reserved.
Cable recommendation
FPower: 0.5 mm² +/- PE shielded
FNMEA: Shielded twisted pair (GPS / INS IN / INS OUT)
FAlarm: Shielded two wires (e.g. 0.5 mm²)
FLAN: Cat5e or better, shielded (STP)
Power: Lit when the device is on.
Rx: Flashes when receiving Navtex data on any
active frequency.
Test: Lit when self test is passed. Flashes if a fault
is detected.
Screw M4x12
TORX 20
(5 pcs.)
Screw ST3.9x19
TORX
(5 pcs.)
Mounting tool for
terminal blocks
Cable Tie
5x200 mm (8 pcs.)
190mm
270mm
42.5mm
LED overview
Minimum cable entry
15.5 mm124 mm50.5 mm
12 mm
246 mm
12 mm
4 x M4 or hole for
self-tapping ø3.8 mm
190 mm
270 mm
150 mm
Disclaimer: Any responsibility or liability for loss or damage in connection with the use of this product and the accompanying documentation is disclaimed by Thrane & Thrane. The information in this manual is provided for information
purposes only, is subject to change without notice and may contain errors or inaccuracies. Manuals issued by Thrane & Thrane are periodically revised and updated. Anyone relying on this information should acquire the most current
version e.g. from cobham.com/satcom or from the distributor. Thrane & Thrane is not responsible for the content or accuracy of any translations or reproductions, in whole or in part, of this manual from any other source. Thrane &
Thrane A/S trading as Cobham SATCOM
Copyright © 2013 Thrane & Thrane A/S. All rights reserved.
Cable recommendation
F Power:
F NMEA: Shielded twisted pair (GPS / INS IN / INS OUT)
F Alarm:
AWG26)
F LAN: Cat5e or better, shielded (STP)
Power: Lit when the device is on.
Rx: Flashes when receiving Navtex data on any
active frequency.
Test: Lit when power on self test is passed. Flashes if
a fault is detected.
+/- PE shielded, 0.5 mm² (AWG20)
Shielded two wires (e.g. minimum 0.15 mm² -
Screw M4x12
TORX 20
(5 pcs.)
Screw ST3.9x19
TORX
(5 pcs.)
Mounting tool for
terminal blocks
Cable Tie
5x200 mm (8 pcs.)
190 mm
270 mm
42.5 mm
LED overview
Minimum cable entry
15.5 mm
124 mm
50.5 mm
12 mm
246 mm
12 mm
4 x M4 or hole for
self-tapping ø3.8 mm
190 mm
270 mm
150 mm
Disclaimer: Any responsibility or liability for loss or damage in connection with the use of this product and the accompanying documentation is disclaimed by Thrane & Thrane. The information in this manual is provided for information
purposes only, is subject to change without notice and may contain errors or inaccuracies. Manuals issued by Thrane & Thrane are periodically revised and updated. Anyone relying on this information should acquire the most current
version e.g. from cobham.com/satcom or from the distributor. Thrane & Thrane is not responsible for the content or accuracy of any translations or reproductions, in whole or in part, of this manual from any other source. Thrane &
Thrane A/S trading as Cobham SATCOM
Copyright © 2013 Thrane & Thrane A/S. All rights reserved.
Cable recommendation
• Power: +/- PE shielded, 0.5 mm² (AWG20)
• NMEA: Shielded twisted pair (GPS / INS IN / INS OUT)
• Alarm: Shielded two wires (e.g. minimum 0.15 mm² -
AWG26)
• LAN: Cat5e or better, shielded (STP)
Power: Lit when the device is on.
Rx: Flashes when receiving Navtex data on any
active frequency.
Test: Lit when power on self test is passed. Flashes if
a fault is detected.
System Confi guration - Example
98-137263-A
www.cobham.com/satcom
SAILOR 6004 Control Panel
ACC
AUX
TEST
PWR
SAILOR 6390 Navtex Receiver
NMEA IN (from eg. GPS)
NMEA IN (from INS)
NMEA OUT (to INS)
ALARM RELAY (normally closed)
+
-
+
-
+
-
Active Navtex Antenna
12 VDC @ 60 mA max.
Passive
Antenna
12-24 VDC
SAILOR H1252B Printer
VBAT+
VBAT-
PE
Shield
ON IN
ON OUT
12-24 VDC
32 VDC @ 500 mA max.
GND at talker end
GND at talker end
12-24 VDC
(internal fuse 1 A)
(internal fuse 3.15 A)
The device requires ON IN to be connected to VBAT- in order to power up.
This can be done by a dedicated switch, permanent wiring or connection
to a Cobham device supporting ON OUT (e.g. SAILOR 6004 Control Panel).
For further information about installation, download the
installation manual from www.cobham.com/satcom
  • Page 1 1
  • Page 2 2

COBHAM Sailor 6390 Navtex Installation guide

COBHAM
Brand
COBHAM
Model
Sailor 6390 Navtex
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents