TECHNICAL DATA ATO-08

CALIPER KIT

Form: CS2185

Rev.: 030113

enclosed Caliper Paint is able to withstand intermittent

temperatures up to 900°F (482°C) will resist brake dust and

perform under the harshest braking conditions.

.PRODUCTS .

KIT INCLUDES

251597 Caliper Cleaner

257169 Caliper Paint

Masking Tape

Applicator Brush

SURFACE PREPARATION

All surfaces must be cleaned to ensure that the Caliper Paint will

properly adhere to the caliper or brake drum. Thoroughly clean

the surface with Rust-Oleum® Caliper Cleaner (251597)

following the directions on the package. Note: Follow all safety

instructions. For best results, remove the wheel(s) from the

vehicle and unbolt the caliper to remove the brake pads before

beginning. Do not remove the calipers or brake lines. Use the

enclosed masking tape to protect the surrounding areas of the

brakes, including the brake bleeder screws, brake lines, and

WARNING: If you scrape, sand, or remove old paint, you may

DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN

DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN

SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved

Be sure to read the directions on the back of the enclosed

Caliper Paint before beginning the project. Thoroughly mix the

Caliper Paint (257169) with the enclosed stir stick. Apply paint to

the caliper or drum in thin, even strokes using the enclosed brush.

applied after 24 hours.

DRY & RECOAT

Dry and recoat times are based on 70ºF and 50% relative

humidity. Allow more time at cooler temperatures. Dries to touch

in 2-4 hours, to handle in 5-9 hours and is fully dry after 24 hours

Wait 5-9 hours before reinstalling wheels and 24 hours before