2. Edelbrock
  3. 19251925

Edelbrock 19251925 Operating instructions

  • Hello! I have reviewed the installation instructions for Edelbrock Performer Series carburetor bolts, models 1925, 1901 and 1904. This document details the correct placement of the bolts, with different lengths for front and rear, plus the recommended torque setting. I'm ready to answer any questions you may have.
  • What is the catalog number for these bolts?
    Where should the longer bolts be installed?
    Where should the shorter bolts be installed?
    What is the recommended torque for these bolts?
®
©2008 Edelbrock Corp. Brochure #63-1925
Catalog #1925 Rev 11/08 - AJ/mc
INSTALLATION INSTRUCTIONS
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY AND
THOROUGHLY BEFORE INSTALLING YOU NEW CARBURETOR BOLTS
CATALOG #1925 Carburetor bolts for Edelbrock Performer Series Replacement Carbs for Q-Jet Applications
MODEL: Carburetor bolts for Edelbrock Performer Series Replacement Carburetors for Q-Jet Applications #1901– #1904.
INSTALLATION INSTRUCTIONS: Refer to carburetor installation instructions if necessary. Install bolts with washers in the original location: two long
bolts with washers at the front and two short ones in the rear. Be sure to install the throttle linkage bracket (if equipped) to the rear of the carb with
the two short bolts & washers. Torque all bolts to 10 ft./lbs.
®
©2008 Edelbrock Corp. Brochure #63-1925
Catalog #1925 Rev 11/08 - AJ/mc
INSTALLATION INSTRUCTIONS
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY AND
THOROUGHLY BEFORE INSTALLING YOU NEW CARBURETOR BOLTS
CATALOG #1925 Carburetor bolts for Edelbrock Performer Series Replacement Carbs for Q-Jet Applications
MODEL: Carburetor bolts for Edelbrock Performer Series Replacement Carburetors for Q-Jet Applications #1901– #1904.
INSTALLATION INSTRUCTIONS: Refer to carburetor installation instructions if necessary. Install bolts with washers in the original location: two long
bolts with washers at the front and two short ones in the rear. Be sure to install the throttle linkage bracket (if equipped) to the rear of the carb with
the two short bolts & washers. Torque all bolts to 10 ft./lbs.
/