icstation TX5000 Wireless Charging Mobile Power Supply Owner's manual

1- Parameter

Name: Wireless charging mobile power supply

Model: TX5000

Input voltage PD protocol: 9V2A

Wireless output: 10W/7.5W/5W

Input/output interface: TYPE-C two-way fast charge PD 18W

Input interface: Lightning PD 9V2A

Battery capacity: 5000mAh//3.7V 18.5Wh

2- LED lighting

1) A total of 5 indicators. Four juxtaposed blue lights indicate the electricity level. Each

represents 25% power.

2) The green indicator light in the middle of the two connectors brightens. Indicates that

the output or input of the power bank is starting the fast charge mode.

3) If the middle two lights of the four lights are blinking. Indicates that the FOD foreign

body warning mode is entered.

4) With only 25% of the battery left. Wireless fast charge output mode will be turned off.

3-Button

1) Tap once to wake up the machine. Press and hold for 2 seconds to enter the shutdown

sleep mode.

2) On the front of the product. The strip running to the loop is the touch wake up area,

3) No light indication after touch awakening. There will be no light indication until the

wireless output of this product starts to work.

4-Standby time

1) Automatic standby time of 10 seconds after touching.

2) The standby time for button wake up is 10 minutes.

5-Note:

1. The device can be used in the ambient temperature of 0°C to 35°C. The device can be

stored in ambient temperature ranges from -10°C to 40°C. Using or storing a device

outside at a certain temperature beyond the recommended range may damage the device

or shorten the battery life.

2. Do not allow children or animals to chew or swallow the device.

3. Do not disassemble, modify or repair the equipment by yourself.

4. Do not place magnetic stripe cards (including credit cards, phone cards, passbooks,

and registration cards) near charging devices. In order to To prevent the magnetic field

from damaging the magnetic strip card and the device.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer

could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

RF Exposure Information

The device has been evaluated to meet general RF exposure requirement. The device can be

used in portable exposure condition without restriction.

icstation TX5000 Wireless Charging Mobile Power Supply, TX5000 Owner's manual

Other documents