ADC LoopStar 750 User manual

Category
Networking
Type
User manual

This manual is also suitable for

ADC LoopStar 750 is a cost-effective Ethernet/TDM services platform designed to enable new customer edge applications while maintaining the viability of current services and infrastructures. It is optimized for medium to large enterprises, multi-tenant buildings, or service aggregation. The LoopStar 750 accommodates up to four plug-in interface cards with a full range of Ethernet and TDM interfaces to support a variety of multiservice applications.

ADC LoopStar 750 is a cost-effective Ethernet/TDM services platform designed to enable new customer edge applications while maintaining the viability of current services and infrastructures. It is optimized for medium to large enterprises, multi-tenant buildings, or service aggregation. The LoopStar 750 accommodates up to four plug-in interface cards with a full range of Ethernet and TDM interfaces to support a variety of multiservice applications.

w w w . a d c . c o m + 1 - 9 5 2 - 9 3 8 - 8 0 8 0 1 - 8 0 0 - 3 6 6 - 3 8 9 1
Spec Sheet
LoopStar
®
750
Cost-Effective Ethernet/TDM Services at the Metro Edge
With customers demanding higher speed Ethernet services at lower price points, carriers are
looking for ways to offer new services while maintaining the current revenue streams from existing
services. In addition, service providers would like to extend the life of current infrastructures and
be able to migrate to the next generation of networks at the appropriate time. ADC’s LoopStar
®
700 product family addresses all of these requirements with a cost-effective, multiservice access
platform designed specifically to enable new customer edge applications while maintaining the
viability of current services and infrastructures.
The LoopStar 750 is optimized for medium to large enterprises, multi-tenant buildings or service
aggregation. This powerful unit is NEBS 3 certified and accommodates up to four plug-in interface
cards with a full range of Ethernet and TDM interfaces to support a variety of
multiservice applications:
Ethernet services over DS1, DS3 and SONET/SDH
Multiservice Gigabit Ethernet
T1, E1 or J1 transport over packet networks
Transparent LAN service
Supports Multiprotocol Label Switching (MPLS)
Virtual Private LAN Service (VPLS)
Benefits
Reduces capital, operational and
provisioning expenses
Increases revenue through new data services
Achieves quick return on investment
Extends life of existing network investments
Provides migration path to next generation
IP/MPLS networks
Transports ILEC-quality T1/E1/J1 services
without compromise
Low cost, flexible, easy to manage
and faster to provision
Compact, reliable stackable solution
Centralized management and provisioning
saves significant time and money
2
w w w . a d c . c o m + 1 - 9 5 2 - 9 3 8 - 8 0 8 0 1 - 8 0 0 - 3 6 6 - 3 8 9 1
LoopStar
®
750
Cost-Effective Ethernet/TDM Services at the Metro Edge
Innovation for Next Generation Ethernet and IP Services
Based on a flexible, IP-centric architecture, the LoopStar 750 uses programmable processors to support
new protocols, interfaces and features as they emerge. Incorporating ADC’s suite of management tools,
the LoopStar 750 can support diverse topologies, scale quickly and easily as the network evolves, and
deliver differentiated services on a per-customer basis.
With this versatile platform, the LoopStar 750 enables service providers to:
Deliver high-speed, business-class Ethernet services (such as Internet access, transparent LAN, storage,
VLANs and tag stacking for traffic management, and VPLS).
Support traditional T1 (E1 or J1) circuit-based voice/data/video services over Ethernet/IP with the same
no compromise quality and robustness as a circuit delivered in native TDM over SONET/SDH.
Use their installed SONET/SDH or Ethernet networks to support traditional voice and leased-
line traffic, while moving toward a data-optimized network that can keep pace with customers’
bandwidth needs.
Transport multiservice traffic efficiently across a single network to reach all customers with the same
services and the same service levels.
With the management suite’s full range of performance statistics, fault indication, loopback diagnostics,
and differentiated service provisioning and definition, the LoopStar 750 allows service providers to
create a secure, reliable network that resolves today’s multiservice challenges while setting the stage for
migration to next-generation networking.
9 / 0 6 1 0 2 1 5 6 A E
LoopStar
®
750
Features
• Business-class metro Ethernet services
• Carrier-class circuit emulation over
packet networks
• IP-centric architecture
• DS1, DS3, SONET/SDH or Ethernet for
transport
• High density NEBS 3 platform
• LoopStar 700 In-band or out-of-band
management
Ethernet
TDM
Ethernet
PBX
TDM
GigE with Sub-50 msec PSR
PSTN
IP/MPLS Core
Class 5
Central Office
DS3
NxT1/E1
Ethernet
NxT1/E1
Ethernet
LS
750
LS
750
LS
750
LS
750
LS
745
LS
718
LS
714
3
w w w . a d c . c o m + 1 - 9 5 2 - 9 3 8 - 8 0 8 0 1 - 8 0 0 - 3 6 6 - 3 8 9 1
Specifications
Interface Modules (4 slots) • 1-port GigE (SFP)
• 2-port GigE (SFP, Ring only)
• 1-port OC-12c/STM-4c (SFP)
• 1-port OC-3c/STM-1 (SFP)
• 3-port DS3 (BNC)
• 8-port T1/E1 (RJ48c)
• 8-port 10/100 Base-T (RJ45)
• 8-port 100 Base-FX (Duplex LC)
• Channelized DS3
Management • In-band or out-of-band
• SNMP
• CLI (RS-232 / Telnet)
• FTP to download multiple software images and configurations
• 10/100 Base-T management port (RJ48c)
• 2-port BITS timing interface (RJ48c)
• LoopStar 700 intelligent management
Ethernet Services • 802.1d bridging
• 802.1p prioritization
• 802.1q VLAN tagging/stacking
• VLAN switching
• MPLS/VPLS option
• Rate-limiting per port or VLAN:
- 1 Mb/s increments (1 to 100M)
- 50 Mb/s increments (100 to 1000M)
• 802.3ad Link Aggregation
• Protected Switching Ring (50 m/sec)
• Spanning Tree Protocol
Circuit Emulation Services
Framed or unframed mode • Fixed or Adaptive Jitter Buffer
• Adaptive, BITS, Loop or Internal (Stratum 4) timing modes
• Round-trip and one-way delay measurements
• Local and remote loopbacks
• ANSI t1.231 reports
Physical • 2.2” x 17” x 20” (h x w x d)
• Dual hot-swappable power supplies
• -AC: 90-264 VAC auto ranging
• DC: -36 VDC to -75 VDC
• 75-Watt maximum power consumption
• 0° to 50° C (operating)
• -20° to 80° C (storage)
• FCC Part 15—Class A
• UL 60950
• CE Mark
• CLEI codes
• NEBS 3 certified
LoopStar
®
750
Cost-Effective Ethernet/TDM Services at the Metro Edge
9 / 0 6 1 0 2 1 5 6 A E
LoopStar
®
750
Spec Sheet
Description Catalog Number
LPS-750 AC Package
*Includes: 1 AC power supply and AC power cord, blanking plates, 19" and 23"
rack mount brackets, console cable, License for Basic Software and documentation
LPS-750-AC L1
LPS-750-48VDC Package
*Includes: 1 -48VDC power supply, blanking plates, LPS-750-48DC L1 19" and 23"
rack mount brackets, console cable, License for Basic Software and documentation
LPS-750-48DC L1
Interface Cards
LoopStar 5000/2200/2100 Blank Interface Slot Faceplate
10/100 BaseT Ethernet-8 port
100BASE FX SM-8 port, fixed optics
100BaseFX MM-8 port, fixed optics
Gigabit Ethernet, SFP-1 port, w/o optics
T1/E1/J1-8 port (with NxT1/E1 Uplink)
DS3, Clear Channel-3 port
Dual Gigabit Ethernet Ring, SFP-2 port w/o optics
DS3, Channelized, MLPPP only, support 8 bundles of up to 8 T1s
OC-3/STM-1, Clear Channel-1 port, w/o optics
OC-12/STM-4, Clear Channel-1 port, w/o optics
LPS-7INF-BLNK L1
LPS-7INF-FE L1
LPS-7INF-100SM L1
LPS-7INF-100MM L1
LPS-7INF-Gig L1
LPS-7INF-T1E1 L1
LPS-7INF-DS3 L1
LPS-7INF-2Gig L1
LPS-7INF-DS3C L1
LPS-7INF-STM1 L1
LPS-7INF-STM4 L1
O r d e r i n g I n f o r m a t i o n
Web Site: www.adc.com
From North America, Call Toll Free: 1-800-366-3891 • Outside of North America: +1-952-938-8080
Fax: +1-952-917-3237For a listing of ADC’s global sales office locations, please refer to our Web site.
ADC Telecommunications, Inc., P.O. Box 1101, Minneapolis, Minnesota USA 55440-1101
Specifications published here are current as of the date of publication of this document. Because we are continuously
improving our products, ADC reserves the right to change specifications without prior notice. At any time, you may
verify product specifications by contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc.
views its patent portfolio as an important corporate asset and vigorously enforces its patents. Products or features
contained herein may be covered by one or more U.S. or foreign patents. An Equal Opportunity Employer
102156AE 9/06 Revision © 2006 ADC Telecommunications, Inc. All Rights Reserved
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

ADC LoopStar 750 User manual

Category
Networking
Type
User manual
This manual is also suitable for

ADC LoopStar 750 is a cost-effective Ethernet/TDM services platform designed to enable new customer edge applications while maintaining the viability of current services and infrastructures. It is optimized for medium to large enterprises, multi-tenant buildings, or service aggregation. The LoopStar 750 accommodates up to four plug-in interface cards with a full range of Ethernet and TDM interfaces to support a variety of multiservice applications.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI