Page 5
Preparing for use
- Wash all the detachable parts before use
- Place the juice collector on the unit.
- Insert the filter in the juice collector. Make sure the filter is securely fitted onto the motor
(‘click’).
- Put on the Juicer cover/feeding tube on top of the juicer collector. Then place the pulp
collector on the side of the unit as shown in the diagram.
- Snap the two clamps on the side of the unit until a ‘click’ is heard.
- Lastly, place the juice jug under the spout.
Using the appliance
The appliance will only work if all the parts have been properly assembled and the clamps are
securely locked.
- Wash the fruit or vegetable pieces and cut them into pieces that fit through the feeding tube.
- Turn on the unit by turning the control knob to level 1 for low speed or level 2 for high speed.
- Insert the fruit or vegetable pieces one at a time and press down with the pusher. Never
exert too much pressure on the pusher as it may affect the end result and also damage the
filter.
Level 1: suitable for soft fruits and vegetables (E.g: watermelons, grapes, tomatoes)
Level 2: suitable for any kinds of fruits or vegetables.
Tips
- Always remove seeds from the fruits. (E.g.: plums, peaches, cherries etc).
- Always remove tough skins from the fruits. (E.g.: melons, pineapples, cucumbers, potatoes
etc).
- Soft-skinned and other foods just need washing (E.g.: apples, pears, carrots, radishes,
lettuce, cabbage, parsley, spinach, grapes, strawberries, celery etc).
- Never use extremely soft fruits such as avocadoes or bananas as it may get blocked in the
filter.
- Always press the pusher very softly in order to remove the maximum amount of juice