Wir
1
1.
2.
3.
4.
R ead thes e i nstructions .
Guard this m anual.
Obey a ll a lerts .
Follow a ll instructions .
5. WAR NING: To prevent fire or shock hazard, do not expos e this equipment to rain or mois ture. Do
not s tore and operate this product near liquid.
6. Clean only with dry cloth.
7. Not s tore and not operate this product near any heat s ources s uch as radiators and h eat regis ters ,
s tove or other appliances (including amplifiers ) that produce heat. K eep this product in a well
ventilated place.
8. Not ignore the s afety purpos e of the polarized or grounding plug. A polarized plug h as t wo blades
being wider than the other. A grounding plug has two blades plus a round pin to ground. The wide
blade or the third prong is intended to provide security. If the p rovided plug does not fit into your
outlet, cons ult an electrician to replace the outlet.
9. Protect
all wires connected to this unit from being walked on or pinched, particularly at plugs and
the point where the cord exits the unit. When unplugging from the electrical outlet, gras p the plug
and do not pull the cord.
10. Dis connect the unit during lightning storms or when long period is to remain unus ed.
11. K eep this unit off when connecting all the devices connected to it.
12. After finis hing the ins talla
tion and connections , connect all your equipment with low volume
level. Once all devices are connected, s lowly increase the volume or level controls to achieve the
proper position.
13. B efore placement, ins tallation, as s embly or s us pending any product, ins pect all e quipment,
s us pens ion, cabinets , trans ducers , brackets and as s ociated equipment.
Any mis s ing component, corroded, deformed, or with non-nominal load can
reduce the i ntens ity,
placement and arrangement of the ins tallation s ignificantly. Any of these c onditions can reduce the
s ecurity of the facility and mus t be corrected immediately.
Us e only s uitable equipment for the loading conditions of the ins tallation and that any p oss ibility of
reducing term, unexpected overload, never exceed the capacity of the m aterial or equipment.
14. C ons ult a licens ed profes s ional t
o ins tall the equipment and make s ure that all local, regional
and national regulations related to s ecurity are unders tood and adhered to.
15. All s ervices s hould be performed by qualified profes s ionals . S ervicing is required when the
apparatus has been damaged in any way, as if having the power cord or its d amaged connector, or
if the machine breaks contact with liquid or if any object is ins erted in th
e unit or if the unit is
exposed to rain or mois ture, or if the unit does not operate normally, or has been dropped.
CHAR GE THE B ATTE RY FULLY B E FOR E FIR S T US E TO OPTIMIZE ITS LIFE TIME
PE R FOR MANCE .
