Omega iBTX-M Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Omega iBTX-M Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ADDENDUM
iSERVER - ADDENDUM
For iBTX-M
These changes are the result of the following product enhancement:
New case mounting design.
This addendum applies to Part 2 Hardware in your iServer Operator’s Manual.
2.1 Wall Mounting
Position unit where required. Mark and drill the two #4 screw holes.
After bracket is mounted on the wall, align back of unit over the three bracket clips, once
engaged, slide downward, the unit will snap in place.
Figure 2.1 - Mounting Bracket
2.42 [61.6]
1.50 [38.1]0.46 [11.7]
1.31 [33.3]
Dimensions are in
inches with
millimeters in [ ].
REAR WIRE
ENTRY AREA
DRILL 0.125 [3.17]
USE TWO, #4
FLAT HEAD SCREWS
TO MOUNT BRACKET
BRACKET CLIPS (3)
SNAP
M4223A/0807
Figure 2.2 Dimensions
3.2 [82]
2.42 [61.6]
3.56 [90.3] 2.00 [50.8]
9.15 [232.3]
0.12 [3.0]
1.44
[36.6]
Dimensions are in
inches with
millimeters in [ ].
0.10
[2.54]
/