Omega iBTX-M Owner's manual

ADDENDUM

iSERVER - ADDENDUM

For iBTX-M

These changes are the result of the following product enhancement:

New case mounting design.

This addendum applies to Part 2 Hardware in your iServer Operator’s Manual.

2.1 Wall Mounting

Position unit where required. Mark and drill the two #4 screw holes.

After bracket is mounted on the wall, align back of unit over the three bracket clips, once

engaged, slide downward, the unit will snap in place.

Figure 2.1 - Mounting Bracket

2.42 [61.6]

1.50 [38.1]0.46 [11.7]

1.31 [33.3]

Dimensions are in

inches with

millimeters in [ ].

REAR WIRE

ENTRY AREA

DRILL 0.125 [3.17]

USE TWO, #4

FLAT HEAD SCREWS

TO MOUNT BRACKET

BRACKET CLIPS (3)

SNAP

M4223A/0807

Figure 2.2 Dimensions

3.2 [82]

2.42 [61.6]

3.56 [90.3] 2.00 [50.8]

9.15 [232.3]

0.12 [3.0]

1.44

[36.6]

Dimensions are in

inches with

millimeters in [ ].

0.10

[2.54]