Ryobi RY4CSS Owner's manual

Type
Owner's manual

This manual is also suitable for

Ryobi RY4CSS is a powerful and versatile tool that can help you tackle a variety of tasks around your home and garden. With its easy starting system and reliable performance, the RY4CSS is perfect for beginners and experienced users alike. It features a strong 33 cc engine that delivers plenty of power for cutting through thick brush and branches. The RY4CSS also has a number of safety features, including a blade guard and a throttle lock, to help keep you safe while you work.

Ryobi RY4CSS is a powerful and versatile tool that can help you tackle a variety of tasks around your home and garden. With its easy starting system and reliable performance, the RY4CSS is perfect for beginners and experienced users alike. It features a strong 33 cc engine that delivers plenty of power for cutting through thick brush and branches. The RY4CSS also has a number of safety features, including a blade guard and a throttle lock, to help keep you safe while you work.

WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
Go to www.ryobitools.com and register your new tool on-line. For any questions about
operating or maintaining your product, call the Ryobi® Help Line! Your Product has been
fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips
are also available in your operator’s manual. For additional registration instruction, refer
to operator’s manual.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole.
Later uses: Check engine lubricant level and add lubricant if needed.
Carefully pour fuel into the tank. Avoid spillage.
Immediately replace fuel cap and hand tighten.
Wipe up any fuel spillage.
PRIME press the PRIMER BULB 10 times
slowly.
SET CHOKE lever to “FULL CHOKE”
position. Squeeze throttle trigger fully through
step 6.
Press the PRIMER BULB 10 times
slowly. Set choke lever to RUN. Pull
starter grip and rope until the engine
runs.
DEPRESS the “STOP” switch to the STOP position
Warm Engine:
After 10 seconds, SET CHOKE lever to the
RUN position.
Cold Engine:
To Stop:
With throttle fully engaged, PULL starter grip
and rope sharply until engine runs. (Max 3 times)
If 60°F or lower, continue to pull starter grip and
rope until engine runs.
If 60°F or above, set CHOKE lever to “HALF
CHOKE” and pull starter grip and rope until
engine runs.
ENGINE STARTING PROCEDURE
1
2
3
4
4
5
5
2
4
1
6
3
5
6
LUBRICANT
1 GALLON
GAS
10x
HALF
CHOKE
RUN
10x
RUN
FULL
CHOKE
RUN
HALF
CHOKE
CALL
1-800-860-4050
www.ryobitools.com
995000057
9-9-16 (REV:01)
NOTICE
Do not use E15 or E85 fuel in
this product. It is a violation of
federal law and will damage
the unit and void your warranty. Only use unleaded
gasoline containing up to 10% ethanol.
  • Page 1 1
  • Page 2 2

Ryobi RY4CSS Owner's manual

Type
Owner's manual
This manual is also suitable for

Ryobi RY4CSS is a powerful and versatile tool that can help you tackle a variety of tasks around your home and garden. With its easy starting system and reliable performance, the RY4CSS is perfect for beginners and experienced users alike. It features a strong 33 cc engine that delivers plenty of power for cutting through thick brush and branches. The RY4CSS also has a number of safety features, including a blade guard and a throttle lock, to help keep you safe while you work.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI