SilverCrest STV 40 A1
US-EN - 11
Remove the thread protector from the drive shaft of the motor unit (8). Then slide the rotor
blade (4) onto the motor unit (8). Make sure that the recess on the rotor blade (4) engages
in the pin of the drive shaft on the motor unit (8).
Attach the rotor blade (4) to the motor unit (8) with the rotor blade nut (3). To do so, tighten
the rotor blade nut (3) counter-clockwise.
Remove the nut (13) and the screw (14) from the front protective grille (1).
Hang the front protective grille (1) onto the rear protective grill (6). Make sure that the hole
in the frame of the front protective grille (1) lies over the hole of the rear protective grille (6).
Insert the supplied screw (14) into the hole in the frame of the front (1) and rear protective
grille (6) and attach it with the help of the nut (13). Then close the hinges (2) of the front
protective grille (1) so that they engage on the frame of the rear protective grille (6).
7.3 Fuse change (in case of a defect)
a) Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on
cord.
b) Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
c) Remove fuse carefully.
d) Pry the fuse out of the socket with a small screwdriver.
e) Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse (provided with product).
f) Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
8. Initial Use
8.1 Switching the Fan On and Off
Proceed as follows to put the fan into operation:
Place the fan on a level, stable surface.
Connect the plug to a properly installed socket.
Turn the fan on by selecting one of the three speed levels on the control panel (12):
o Level 1, low: Press button 1
o Level 2, medium: Press button 2
o Level 3, high: Press button 3
Press button 0 to turn the fan off.