Page is loading ...
© 1991 by Community Products, LLC
UW46 DC 6656 Revision U
Product
Guide
User and
Maintenance
Information
IMPORTANT
INFORMATION:
Please save this
product guide.
CUSTOMER SERVICE:
United States
PO Box 2
Ulster Park, NY 12487
Office hours: 9-5 EST
Phone (800) 777-4244
Fax (800) 336-5948
(845) 572-3468
www.CommunityPlaythings.com
Sales@CommunityPlaythings.com
Recommended Use
Used with the Community Playthings Changing
Station, the Wall-Mounted Shelf provides easy
accessible storage for each infant’s personal
items. Locate shelf within easy reach of the
Changing Station so the infant will never be left
unattended.
This shelf contains a built-in dispenser which
can dispense roll materials such as paper tow-
els. It will accommodate a roll up to 12” wide by
8” in diameter. If you do not want the dispenser
function, simply remove the dowel and use the
space as a shelf.
WARNING
cThis product is intended for use with children of
immature judgement. Supervision is required at
all times.
CAUTION
cFor indoor use only. This shelf is not waterproof.
Assembly
Equipment comes in a single carton.
The carton contains:
1. One Wall-Mounted Shelf
2. A carton containing seven shelf dividers and a
packet of ten label holders and labels.
3. A dowel for the roll dispenser.
4. This Product Guide.
If your shipment is incomplete, please contact
Customer Service.
G28 Wall-Mounted Shelf
Installation
Installation of your Wall-Mounted Shelf should be
done by a competent carpenter or maintenance
person.
1. Position shelf at the desired place on the wall.
2. Locate the fasteners to suit the wall construction,
with at least one fastener near each end of the
cleat shown. (Fig.A)
3. Predrill the cleat at these locations.
4. Attach the shelf to the wall with fasteners appro-
priate to the wall construction and the weight of
the fully loaded shelf.
WARNING
The shelf must be properly mounted before use.
The customer must assume full responsibility
that the shelf will be secure for the long term.
Operation
To install or remove shelf dividers, lift the divider
against top of upper groove, then swing bottom of
divider to the side. (Fig.B)
To dispense perforated roll materials, pull until
perforation is exposed, then pull sharply down and
diagonally to the side for easy one-hand operation.
Accessories
The G282 Mirror is designed to be used with the
G28 Wall-Mounted Shelf in conjunction with the
Changing Station. The Mirror catches a child’s atten-
tion while changing the diaper. Two screws attach
the Mirror to the underside of the lower shelf using
the already pre drilled holes.
Figure A
Figure B
Screws
© 1991 by Community Products, LLC
UW46 DC 6656 Revision U
CUSTOMER SERVICE:
United States
PO Box 2
Ulster Park, NY 12487
Office hours: 9-5 EST
Phone (800) 777-4244
Fax (800) 336-5948
(845) 572-3468
www.CommunityPlaythings.com
Sales@CommunityPlaythings.com
Page 2
Maintenance
Information
G28 Wall-Mounted Shelf
Maintenance
Periodically inspect for cracks, breaks, and or loose
fasteners. Remove the product from service when
any condition develops that might make use unsafe.
Cleaning
Clean shelves with a mild detergent and water. Too
much water will harm the finish of the wood.
Construction
This product is made of solid maple, finished with
a clear nontoxic finish. The dividers are of birch ply-
wood. All edges and corners are rounded for safety
and ease of cleaning.
Packaging Recycling
All our packaging is recyclable in two simple
categories:
Please help us preserve the earth for the children and
recycle at an appropriate facility.
Packaging Materials Recycling Category
Cardboard boxes and
pads, newsprint
corrugated cardboard
Plastic wrap, sheet
foam, foam pads
Plastic #4 LDPE
User Modifications
We are not responsible for modifications made by
customers to our products, without our supervision,
testing or evaluation.
Ordering Parts
To order replacement parts, contact your Customer
Center with a description of the part(s) needed and
the ID Code from the product.
Use only replacement parts supplied by
Community Playthings.
/
