Astria Fireplaces Villa Vista Instruction Sheet

Type
Instruction Sheet
1
FLUE COLLAR SCREWS
EPA FIREPLACES
P/N 900860-00
Rev. NC, 07/2017
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS (included in literature package provided with appliance)
4 ea. Screws, #10 x 3/4” TEK
1 ea. Instruction Sheet
GENERAL INFORMATION
This instruction sheet explains how to secure the first pipe section to the
flue collar on top of the appliance using the 4 screws provided.
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
INSTALLATION INSTRUCTIONS
This appliance is equipped with a generic vent flue collar that will require
the first vent section of pipe to be secured with four screws (equally
spaced around circumference). Install the first section of pipe as shown
in Figure 1.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Printed in U.S.A. © 2017 Innovative Hearth Products
P/N 900860-00 Rev. NC 07/2017
IHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor
for fireplace code information.
Innovative Hearth Products
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
Figure 1
INSTALLATION OF FIRST PIPE SECTION TO FLUE COLLAR
[FIREPLACE MODELS WRT3820WS, WRT4826WH, WCT6820WS, WRT4820WS, WCT4820WS, LADERA, MONTECITO, VILLA VISTA SERIES, AND BRENTWOOD SERIES]
Fireplace
Top
Collar
Chimney Pipe
#10 x 3/4” TEK Screw
(4 places)
  • Page 1 1

Astria Fireplaces Villa Vista Instruction Sheet

Type
Instruction Sheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI