2. Gatekeeper Systems
  3. NITRO 401
NITRO 401

Gatekeeper Systems NITRO 401 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Gatekeeper Systems NITRO 401 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
401/404
VCR Retrofit to N401
Protecting
Your
Precious Cargo
©
Gatekeeper Systems Inc
PDN1102
Jun 9
, 2010
V2
.0
#301 31127 WHEEL AVENUE
ABBOTSFORD. B.C. V2T 6H1
TOLL FREE: 1.888.666.4833
TEL: 1.604.864.6187
FAX: 1.604.864.8490
gatekeeper-systems.com
Installation Guide
Refer to below pictorial instructions for setting up proper connections to retrofit your current Gatekeeper VCR to
NiTRO
TM
401 recorders with or without GPS Module :
To “
Cam 1
”
Connector
on N401
To “
Power
”
connector
on N401
To
“Sensors”
connector
on N401
To “
GPS
”
connector
on N401
CAB000215
(Power Sensor/GPS to DB25)
Existing VCR Power
Harness DB25
Connector
To “
Cam
era Harness”
CAB000212
(Composite Video Adaptor-1 Channel)
CAB000214
(Power Sensor to DB25)
To “Power” connector on N401
To “Sensors” connector on N401
GSWHC2-XX
(existing Camera Harness)
Rear View of NiTRO
TM
401
401/404
VCR Retrofit to N401
Protecting
Your
Precious Cargo
©
Gatekeeper Systems Inc
PDN1102
Jun 9
, 2010
V2
.0
#301 31127 WHEEL AVENUE
ABBOTSFORD. B.C. V2T 6H1
TOLL FREE: 1.888.666.4833
TEL: 1.604.864.6187
FAX: 1.604.864.8490
gatekeeper-systems.com
Installation Guide
a) Disconnect the VCR power cable (16 AWG white wire & black wire) from the battery. Cut the cable to remove the VRS
TM
Box Assembly from the VCR power cable. Insert a piece of 2.5 inches length 1/4” heat shrink to one end of the cable. Strip 1/4”
(6mm) of the wire insulation from the end of each wire. Reconnect the “Live” wires (white) and the “Ground” wires (black) by crimping
the Butt Connectors (not provided) with proper crimping tool. Protect the connections by heating up the heat shrink.
b) Connect the provided 2 Ampere Fuse Assembly to the “Live” wire of the VCR power cable. Then reconnect the power cable to the
battery.
(B) On existing Gatekeeper VCR power harness, proceed with the following instructions :
/