User manual for shower cabins
I. Safety
1. Important: Read and keep this manual
Read through the entire manual before using the cabin and control
panel. Save these instructions for future reference.
2. Varningssymboler
Electricity warning – dangerous voltage
Important operating and maintenance information
3. Varning
The control panel contains electrical components with dangerous
voltage. Repair of the control panel should only be carried out by
qualied professional persons.
To avoid re or electrical shock, the control panel should only be
opened in a dry environment and when the cabin is dismounted from
the mains.
Electrical modications carried out without the approval by the manu-
facturer can cause danger to persons using the cabin, and warranty
void.
If a child is going to use the steam cabin on it’s own, make sure the
child is well understood by the steam cabin’s functionality, and that it
can handle the cabin properly.
4. Important: Using the cabin and control
panel
Before turning on the system, ensure all cables are connected
properly.
The mains power must match the voltage specied on the electro
nics box, otherwise it might not work or it might broke.
Turn o the cabin via the control panel when it’s not in use. If the
cabin will not be used for a longer period, it is recommended to
disconnect the cabin from the mains.
If the control panel freezes, disconnect the cabin from the mains for
ten seconds and then restart the cabin.
Avoid exposing the control panel to high heat, direct sunlight,
m echanical vibration, impact and dirt.
5. Service
For service and repair, contact your local dealer or the manufacturer.
II. Quick information
1. Electric specications
Voltage: AC220V (198~242V)
Frequency: 50Hz/60Hz
Working temperature: +5 °C ~ +40 °C
2. LCD display content
Small functional variations may exist between dierent models.
Screen lock Over head light Wall light
3. Devices controlled from the control panel
Over head light: DC12V/5W
Wall light: DC12V/5W
Speaker: 8Ω/15 W
4. Control panel
Ver: 21 August 2019 2:25 pm
Model: 6006, 6007, 6016, 6026, 6030
If a child is going to use the steam cabin on it’s own,
make sure the child is well understood by the steam
cabin’s functionality, and that it can handle the cabin
properly.
If the control panel freezes, disconnect the cabin from
the mains for about ten seconds. Then restart the cabin.
!
Arrow Skandinavien AB
Tel: +46 (0)31 330 00 10
www.arrowshower.com
III. User guide for control panel
1. ON/OFF
Press the Power button to turn the system on. The lights comes on
and the lamp symbol lights up on the display. Press the Power
button again to turn the system o.
2. Screen lock
The screen lock is activated when no button is pressed for a few
minutes. The key symbol
lights up and all buttons are disabled.
Press any button for 3 seconds to unlock the screen.
3. Overhead light
Press the button for overhead light to turn the overhead light
on. The overhead light symbol lights up on the display. Press
the button again to turn the light o. The overhead light will turn on
automatically when the cabin is turned on.
4. Wall light
Press the button for wall light to turn the wall light on. The wall
light symbol lights up on the display. Press the button again to
turn the light o.
5. Media: FM radio
5.1 ON/OFF
Press the Media button to turn the radio on. The radio frequency is
shown on the display. Press the Media again to turn the radio o.
5.2 Change frequency
Press < or > to decrease or increase the frequency (87,5 –
108,0 MHz). Press and hold < or > button for 2 seconds to search
for the next radio station. The current frequency will be shown on the
screen.
5.3 Save a radio channel
Save the current frequency as a channel, press the Set button one
or several times until the text “CH” is blinking on the display. Choose
a channel by using < or >. Press the Mem button to save.
5.4 Switch between channels
To switch between channels, press the Set button one or several
times until the text “CH” lights up (not blinking). Press < or > to
change channel. Conrm by pressing the Media button or wait
5 seconds.
5.5 Volume
To change the volume, press the Set button one or several times
until the text “VOL” lights up (not blinkingg). Press < or > to change
the volume. The display will return to the prevoius menu after
5 seconds.
IV. Cleaning
Use a soft cloth and a mild detergent. Do not use a detergent con-
taining abrasives, acetone or ammonia. Limescale can be removed
using lime dissolving detergent. Drain and nozzles should be
cleaned regularly to prevent clogging. Chrome-plated parts should
be polished with care.
/