Audiovox AA-9093 Installation guide

Brand: Audiovox

Model: AA-9093

Type: Installation guide

:'llE copy!

AA -9093 !

MINI MICROPHONE

GLASS-BREAK DETECTOR

INSTALLATION GUIDE !

Form No. 128-4320A I

AUDIOVOX SECURITY

Printed in U.S.A.

2. Connect the BLACK wire from the module to a solid

chassis ground source in the vehicle.

3. Connect the WHITE wire from the module to the negative

instant trigger wire of the security system. This will be

the DARK GREEN or LIGHT GREEN wire on most

AUDIOVOX security systems.

MOUNTING INSTRUCTIONS:

1. Select a suitable mounting area behind the dash, for

mounting the glass break module. Be sure the sensi-

tivity adjustment screw on the module is left accessible

for adjustment later in the installation.

Mount the module using the screws provided, or it can

be secured to an existing bracket or wiring harness

using a cable tie.

ADJUSTMENTS:

1. Turn the sensitivity adjustment screw on the module fully

counterclockwise, and then clockwise about 114 turn.

2. Arm the alarm, wait five seconds, then gently tap the rear

window using a coin or key. The red L.E.D. on the

module will illuminate when the noise is detected by the

microphone.

3. If the alarm sounded, no further adjustment should be

necessary .If the alarm did not sound turn the sensitivity

adjustment screw on the module 118 turn clockwise, and

re-test. Repeat this procedure until the alarm sounds.

INSTALLING THE MICROPHONE:

1. The microphone can be mounted between dash panels.

or along the driver's side A pillar. The microphone

should always be exposed, and never concealed be-

hind a panel or trim moulding.

2. Double sided adhesive tape can be used to hold the

microphone in place.

3. Route the microphone extension to the control module,

and plug it into the mating port on the module. Be sure

to cable tie the extension in place along the routing

path.

NOTE: Setting the sensitivity too high will cause false

alarms caused by noises outside the vehicle.

WIRING THE SENSOR:

1. Connect the RED wire from the module to a fused

+ 12VDC constant battery source.

Audiovox AA-9093 Installation guide

Audiovox AA-9093 Installation guide

Audiovox AA-9093 Installation guide

Related papers

Other documents