![](//vs1.manuzoid.com/store/data-gzf/5d14e859cf9c73ad4d6ca97214f8a78c/2/002373015.htmlex.zip/bg2.jpg)
3. - To measure distances to multiple targets in succession,
PRESS and RELEASE to power on. Then HOLD
, the
and change targets.
NOTE: While scanning in P.A.T. Mode, the measurement will only change when a shorter distance
---
Y
SLOPE ON
---
Y
SLOPE OFF
HOW TO USE
, PRESS & RELEASE
the
is now powered on.
1. To focus/increase clarity, use
the by
turning the .
2.
,
aim the at your
intended target & PRESS the
will appear to the right
of the The
measurement will be displayed at the
top of the LCD display.
3.
2. P.A.T. mode is best used when measuring the
P.A.T mode, PRESS the once while the device is powered
LCD display (Fig. B).
1. Standard mode is recommended when measuring distances
to larger objects. (Fig. A)
164
---
Y
4. To change the unit of measure from yards to meters,
start with the device powered on. Then HOLD the
of the distance displayed.
on the side of the LZ-i has two positions:
GREEN is showing: Slope adjusted yardage
tournament legal when the slope is enabled.
2. RED is showing: The laser is tornament legal
HOLDMode Button