Extron MR D Series Template

MR D Series
Extron
Brand
Extron
Model
MR D Series
Type
Template

This manual is also suitable for

1 2 3 4 5 6 7
Cut here for 1-gang.
Cut here for 2-gang.
Cut here for 3-gang.
Cut here for 4-gang.
Cut here for 5-gang.
Cut here for 6-gang.
7-gang template
68-1612-01 Rev. A 06 08 www.extron.com
B. Level the template on the
mounting surface and
trace it.
C. Cut along the inside of
the traced line.
A. Verify that the printed template
is the correct size, then cut the
card to the desired number of
sections.
Level
Cut material.
Trace template.
Place at least 1" from the stud.
Full Size Cutout Template for MR Series Mounting Brackets
3
4
5
6
7
1
2
1 2
D. Insert the mud ring into the
opening, and tighten the
dogleg screws.
If you are printing this card to cut out and use as a template,
• Print on 17" by 11" (tabloid or ledger) paper, in landscape orientation.
• Set page scaling to None.
• After printing, verify that the dimensions of the printed card match those printed on it. Your printer configuration may cause the card to be printed smaller or larger than specified.
Printing Instructions
3
31
32
3
"
x
3
7
8
5
"
x
"
25
32
3
7
8
7
"
x
"
13
32
3
7
8
9
"
x
"
3
7
8
11
"
x
3
7
8
13
"
x
"
19
32
2
10.03 x 9.83 cm 14.68 x 9.83 cm 19.23 x 9.83 cm
23.83 x 9.83 cm
28.50 x 9.83 cm
33.20 x 9.83 cm
5.41 x 9.83 cm
5
32
3
7
8
"
x
"
7
8
"
7
32
"
3
32
  • Page 1 1

Extron MR D Series Template

MR D Series
Extron
Brand
Extron
Model
MR D Series
Type
Template
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents