DIP SWITCH SETTINGS:
AMPLIFIED SYSTEMS
For vehicles with an amplified system, connect the Rear Channel wires to the Front Channel wires of the
aftermarket radio. If amplified, FADER is NON-Adjustable.
VIOLET GRAY
VIOLET/BLACK GRAY/BLACK
GREEN WHITE
GREEN/BLACK WHITE/BLACK
USING A RELAY
The module is rated at up to 2A max power output. For
applications demanding a continuous output of 3A or
more, we recommend using a standard Bosch (SPDT)
relay.
Below is a diagram on how to install the relay
When replacing the radio with a 4.3” OR 8.4” screen, you will need to tap the CAN signals along with Power,
Ground, and Speakers from the factory White 22-Pin connector. Tap the wires as shown below. Again, these
connections are made on the factory White 22-pin connector.
