Post Shields 12020 Installation guide

Type
Installation guide
Each side has a hook and a arrow
for connection. You can slide or snap
each shield together.
No Screws or Nails
No Tools Needed
© 2019 Post Shields All Rights Reserved
This example shows the preferred
method of installation: Snapping the
shields together
© 2019 Post Shields All Rights Reserved
Push the arrow side of the shield into
the hook side with some force. You
could use a rubble mallet if needed
© 2019 Post Shields All Rights Reserved
You will hear a snap sound when they connect
creating your complete protection around your post.
© 2019 Post Shields All Rights Reserved
Assemble 3 shields together
and wrap around the post
Then slide or snap the
last shield into place
© 2019 Post Shields All Rights Reserved
If sliding the shields, align the hook and arrow and push
down. There will be some friction and will take some force.
You could use a rubber mallet if needed.
© 2019 Post Shields All Rights Reserved
Final top view
© 2019 Post Shields All Rights Reserved
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Post Shields 12020 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI