Actor 6/Actor 6 ST
Barndoors for Actor 6 (ST)
Installation instructions
Disconnect the fixture from mains before barndoors installation
1.Unscrew the four fastening screws (2) which securing adaptor (1) to the head and screw the new adaptor (3).
Keep its right position- the cutouts (A) in the adaptor have to look towards the fixture arms.
2.Put the barndoors holder (4) on the head in this way that pins (D) have to be in slots (B) in the adaptor (3) , press
locks (5) and turn the top hat counter-clockwise until it snap into slots (B) in the flange and release locks (5).
3. Insert the barndoors (8) into the second slot in the barndoors holder (4) and secure it by means of the lock (6).
The first slot serves for diffuser (9), which has to be secured by means of the lock (7).
4. On each side of the fixture, pull the snap hook (11) on the wire (10) through the aperture (12) to make the
secondary security of installed barndoors.
Version 1.0
January 15, 2016 ROBE Lighting
/
