Virtu USA zMD-415-S-HO Installation guide

Type
Installation guide

This manual is also suitable for

Prior to installation, please check the items you
have received against the packing list. Report any
missing items to your local dealer immediately.
Protect all surfaces from sharp objects, high heat
sources, direct prolonged sunlight and chemical
hazards.
Professional installation is recommended.
www.virtuusa.com
MD-415
PARTS LIST
TopBasinCabinet Mirror
(may differ depending on purchase)
INSTALLATION INSTRUCTIONS
SKU:
REV3.19.18
17"~26"
~77"
Shelf
Anchor & Screw
~31"
Bracket
www.virtuusa.com
MD-415
INSTALLATION INSTRUCTIONS
SKU:
REQUIRED TOOLS
DRAWER REMOVAL
DOOR ADJUSTMENT
REMOVAL
1. Pull tabs toward center
2. Lift and pull drawer out
RE-INSTALL
1. Align drawer hole with slider stud
2. Push tabs back in to secure
Adjusts the door vertically Adjusts the door horizontally Adjusts the door forward and backwards
Locate the slider tabs on the underside
of the drawer.
REV3.19.18
www.virtuusa.com
MD-415
INSTALLATION INSTRUCTIONS
SKU:
REV3.19.18
Mark at distances shown below. Drill holes.
Bracket Installation
Install drywall anchors into holes.
Take the threaded washer
(inset facing outward) and put the long
screw through. Install the screwinto the wall.
Repeat for the other bracket.
Take the metal caps and twist clockwise
until secure.
Note: The above sets the brackets visible
on the ends. To hide the brackets, decrease
the distance between the two brackets.
www.virtuusa.com
MD-415
INSTALLATION INSTRUCTIONS
SKU:
REV3.19.18
~27.5"
Cabinet Installation
Measure height and mark.
Drill holes.
Install anchors
into holes.
Take cabinet and place
onto brackets. Check and ensure
cabinet is leveled. Once positioned,
secure screws at the wall and use short
screws on the underside.
Apply adhesive around the top edges of the
cabinet.
Carefully place the top over the cabinet. Align
basins and apply water sealant around edges.
Complete the vanity with faucets.
Follow instructions included with the faucets.
www.virtuusa.com
MD-415
INSTALLATION INSTRUCTIONS
SKU:
REV3.19.18
Shelf Installation
Mark the distances shown or
as desired. Drill holes.
Install anchors into holes.
Install screws into into anchors.
Optional
Use the included threaded washer
to install metal caps to hide screws.
Screw in the
mirrors at the top.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Virtu USA zMD-415-S-HO Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI