Page is loading ...
STEP 8 STEP 9
Install the Support Brackets (Part D) to attach
the rails using 3/8” Bolts (Part I).
Secure the bolts tightly.
Note: There are a total of 4 bolts for the two
support brackets.
Adjust the wing nuts to make the rails straight
and tight.
SETUP INSTRUCTIONS
ASSEMBLY INSTRUCTIONS (CONTINUED)
STEP 6 STEP 7
First install the Short Rail (Part A) to the platform
frame using 1/2” Bolts (Part K). If the holes do not
line up - adjust the adjustment wing nuts until
the holes line up with the brackets. Install Long
Rails (Part B) using 1/2” Bolts (Part K). Secure the
bolts tightly.
Use 5/8” Bolts (Part J) to attach the end legs.
Secure the bolts tightly.
14
SIZES: DB, QN, EK, CK
I
I
D
J
K
A
B
B
STEP 1
HARDWARE LIST
A. Short Rail
(1 pc)
Platform Bed Setup Instructions
Contains One (1) Bed and Hardware
IMPORTANT NOTE:
Carefully remove all parts from the carton. Arrange on a at
surface to verify all of the following parts and hardware are present.
PART LIST
TOOLS REQUIRED:
Phillips Screwdriver
(Continued on back)
ASSEMBLY INSTRUCTIONS
C. L-Brackets
(2 pcs)
B. Long Rail
(2 pcs)
D. Support
Brackets
(2 pcs)
G. Brackets
(2 pcs)
H. Platform Frame
(2 pcs)
I. 3/8” Bolt (6 pcs) J. 5/8” Bolt (2 pcs) K. 1/2” Bolt (12 pcs) L. Hex Key (1 pc)
E. Short Side Board
(1 pc)
F. Long Side Board
(2 pcs)
Unfold each half and lay at upside down. Raise all six legs to upright position.
Each of the four end legs have separate support arms. Rotate support arms to
hook on to the bolts and tighten with preinstalled wing nuts.
Note: Two center legs do not require support arms and wing nuts.
STEP 2 STEP 3
STEP 4 STEP 5
Turn the bed upright.
Connect two halves together
with keyhole locked in place.
Install the L-Brackets (Part C) onto both Long
Side Boards (Part F) using the 3/8 Bolts (Part I).
Secure the bolts tightly.
Insert the Short Side Board (Part E)
into the Brackets (Part G).
Insert the Long Side Boards (Part F) into the
Brackets (Part G).
32
SIZES: DB, QN, EK, CK
I
C
C
I
F
G
G
E
E
F
F
G
G
/
