VIDEO RECORD
1. Hold down the power button for 2 seconds and
release. The Action Camcorder will vibrate 3 times,
illuminate the blue power LED.
2. Slide the Frame Rate switch to the right side for 60
frames per second or to the left side for 30 fps.
3. Hold down the record button and release, the Action
Camcorder will vibrate 3 times, illuminate the RED
LED and automatically start recording.
4. Hold down the rear button and release, the Action
Camcorder will vibrate 1 time to notify you that it is
saving the file. Then automatically start recording
again.
5. Hold down the record button for 1 second and
release. The Action Camcorder will vibrate 1 time to
notify you that it is saving the file and stop record.
6. Hold down the power button for 2 seconds and
release. The Action Camcorder will vibrate 1 times
and power off.
Note: 1. Your Action Camcorder will exhibit sustained vibration
during the start-up & shut-down sequence, this is normal
operation.
2. The charge LED will illuminate when there is no memory
card inserted properly in the Action Camcorder.