www.atos.com
Cartridges and covers type SC LA-103*, CAPP/10
Two way cartridges, mounting cavity not ISO
Table TH020-0/E
TH020
Size: 10
Two way cartridges
1 MODEL CODE OF SCLA CARTRIDGE
Poppet type: see section
쪩
32, 33, 36, 37
SC LA-1032*
Version with plug
CAPP/10
Spring type and cracking pressure:
1= 0,5 bar
2= 1,3 bar
3= 2,4 bar
6= 5,5 bar
7= 7 bar
Model code
Spring type (Cracking pressure)
1 = 0,3 bar
2 = 1,3 bar
6 = 5,5 bar
350Max pressure [bar]
Max flow (Δp=6 bar) [l/min] 90 75 90 60
1:1,1 1:2 1:1 1:1
Hydraulic symbols
Area ratio
SC LA-1032*
1 = 0,5 bar
3 = 2,4 bar
SC LA-1033*
6 = 5,5 bar
SC LA-1036*
7 = 7 bar
SC LA-10377 CAPP/10
3 TECHNICAL CHARACTERISTICS OF SC LA CARTRIDGES
Two way cartridge valves not conforming
to standard ISO 7368
The cartridges are available with different
shapes and characteristics allowing
following controls:
-pressure relief
-pressure compensator
-pressure reducing
-directional control
-check function
A specific threaded plug CAPP-10 is
available to close the cartridge cavity.
Application
In any application with nominal flow up to
90 l/min they permit to reduce the
manifold dimension then using the
standard cartridges SC LI -16
2 MODEL CODE OF CLOSING PLUG
CAPP-10
A
B
F
/*SC LA 10-32 1
Seals material
-=
NBR
PE = FKM
4Q/Δp DIAGRAMS (based on mineral oil ISO VG 46 at 50 °C)
Flow [l/min]
Pressure drop [bar]
Cavity for SC LA-10 + CAPP-10
CAPP-10
Cavity for SC LA-10
123
1 = SC LA-10321
SC LA-10322
SC LA-10326
SC LA-10366
2= SC LA-10331
SC LA-10333
3= SC LA-10377
5DIMENSIONS [mm]
20 40 60 80 1000
2
4
6
8
10
07/13
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Jura Impressa J9.3 One Touch TFT Instructions For Use Manual
-
Jura IMPRESSA S9 One Touch Manual For Use
-
-
Gaggia RI8701 User manual
-
-
Gaggia MAGENTA MILK Owner's manual
-
-
-
Gaggia MAGENTA MILK Owner's manual
-