INSTALLATION GUIDELINES

These installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed professional, and to

check with your local building inspector or building permit office for approvals and possible variations that may apply.

Measure for correct pipe size

Form flashing base to roof profile

Fasten flashing to complete

Trace flashing Apply sealant

Choose pipe opening and trim Slide flashing over pipe using

water

0.3

4.5 - 5.25

5.25 - 5.75

Pipe Range: ¼ in. – 5 ¾"

Aluminum Base: 8 in. x 8 in.

®