Intratone EEN-ANTD-EDGE Owner's manual

Brand
Intratone
Model
EEN-ANTD-EDGE
Type
Owner's manual

Intratone EEN-ANTD-EDGE is a remote aerial that can be used to improve the GSM signal reception of your EENEEN-MEDGE unit or Visio EENEEN-PIVI3G panel. It is particularly useful in perturbed environments, with a specific layout of surrounding buildings, or to cancel the Faraday cage effect.

The remote aerial complies with GSM and EMC standards, and it is guaranteed to operate within a temperature range of between -35°C and +85°C in which relative humidity does not exceed 70%.

To connect the remote aerial, simply trip the switch downwards, screw the aerial cable to the card's aerial terminal block, and fit the cable pass through supplied in the remote aerial kit.

Intratone EEN-ANTD-EDGE is a remote aerial that can be used to improve the GSM signal reception of your EENEEN-MEDGE unit or Visio EENEEN-PIVI3G panel. It is particularly useful in perturbed environments, with a specific layout of surrounding buildings, or to cancel the Faraday cage effect.

The remote aerial complies with GSM and EMC standards, and it is guaranteed to operate within a temperature range of between -35°C and +85°C in which relative humidity does not exceed 70%.

To connect the remote aerial, simply trip the switch downwards, screw the aerial cable to the card's aerial terminal block, and fit the cable pass through supplied in the remote aerial kit.

Connection of the EEN-ANTD remote aerial
Page 1 / 2 V231 – 0086 – AB
Connection of the
Connection of the Connection of the
Connection of the EEN
EENEEN
EEN-
--
-ANTD
ANTDANTD
ANTD-
--
-EDGE remote aerial
EDGE remote aerialEDGE remote aerial
EDGE remote aerial
to the GSM EEN
to the GSM EENto the GSM EEN
to the GSM EEN-
--
-MEDGE unit or Visio EEN
MEDGE unit or Visio EENMEDGE unit or Visio EEN
MEDGE unit or Visio EEN-
--
-PIVI3G panel
PIVI3G panelPIVI3G panel
PIVI3G panel
Overview:
The remote aerial is not required
. Install it in the case:
• Of a perturbed environment.
• Aspecific layout of surrounding buildings.
• To cancel the Faraday cage effect.
EC standards:
The remote aerial complies with GSM (Radio spectrum) standards EN 301 511 ;
3GPP 51.010-1 and with EMC standards EN 301 489-3 and EN 301 489-7.
Operating warranty
The remote aerial is guaranteed to operate within a temperature range of between -35°C and +85°C in which
relative humidity does not exceed 70%.
End of life product recycling:
The remote aerial and its accessories must not be disposed of with unsorted municipal waste,
but must follow the WEEE (Waste Electrical and Electronic Equipment) collection and
recycling channel.
Connection of the EEN-PIVI3G-V2:
1.
Trip the switch downwards.
"D
O NOT USE A SCREWDRIVER
!"
2. Screw the aerial cable to the card's aerial terminal block.
3. Fit the cable pass through supplied in the remote aerial kit as indicated on the
diagram.
4. Thread the cable through the cable pass through.
Switch
ON
1
1
Aerial terminal block
2
4
Cable pass through
for swan neck
fitting
3
Connection of the EEN-ANTD remote aerial
Page 2 / 2 V231 – 0086 – AB
EEN-MEDGE connection:
General instructions
1.
Prise out the protective cap.
2. Trip the switch downwards.
"D
O NOT USE A SCREWDRIVER
!
3. Make a hole in the cap with a screwdriver and pass the aerial cable through.
4. Screw the aerial cable to the card's aerial terminal block.
5. Refit the cap.
6. Use the cable pass through supplied in the remote aerial kit.
Switch
ON
1
" The remote aerial can only be
installed with the EEN-MEDGE
model with a round cap"
Aerial terminal block
1
2
3
4
5
6
Cable pass through for swan neck
fitting
Fit the aerial to a metal support for optimum reception.
•
Install the aerial high up and outside.
• The aerial must not be installed on a ceiling but
in a vertical position.
• Prefer swan neck cabling.
TOP
BOTTOM
Aerial
Or
  • Page 1 1
  • Page 2 2

Intratone EEN-ANTD-EDGE Owner's manual

Brand
Intratone
Model
EEN-ANTD-EDGE
Type
Owner's manual

Intratone EEN-ANTD-EDGE is a remote aerial that can be used to improve the GSM signal reception of your EENEEN-MEDGE unit or Visio EENEEN-PIVI3G panel. It is particularly useful in perturbed environments, with a specific layout of surrounding buildings, or to cancel the Faraday cage effect.

The remote aerial complies with GSM and EMC standards, and it is guaranteed to operate within a temperature range of between -35°C and +85°C in which relative humidity does not exceed 70%.

To connect the remote aerial, simply trip the switch downwards, screw the aerial cable to the card's aerial terminal block, and fit the cable pass through supplied in the remote aerial kit.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents