Performance Hardware
User’s Guide
Version 1.0 March, 2010
C o r s a i r A i r f l o w P R O
Q u i c k I n s t a l l G u i d e
A pictorial step-by-step of how to install your new Airflow PRO memory activity
and temperature monitor device.
Corsair Airflow PRO Quick Start Guide
1
Remove two screws from the top of
your Dominator Airflow Fan
2
Fasten standoffs to screw locations
Corsair Airflow PRO Quick Start Guide
3
The Airflow Pro display device has six separate data leads for the
activity LEDs. Turn the module over and locate the appropriate con-
nectors for the number of memory modules you have. (Don’t worry,
even if you only have two modules, all six LED banks will still light up
with peak or average memory activity)
Airflow Pro Data Con-
nectors (Photo shows
3 cables connected
out of possible 6)
Airflow Pro Power
Connector (cable not
connected)
Corsair Airflow PRO Quick Start Guide
4
Connect the power cable.
5
Turn your Airflow Pro device over and attach it to the Airflow fan by usin
the two screws from step 1.
Corsair Airflow PRO Quick Start Guide
6
When attached correctly, the top part of the Airflow Pro sits on the Airflow
fan and the bottom is fastened using the thumbscrews that were removed
during step 1.
7
Connect the data cables to the DHX Pro connectors on your Dominator
Memory.
Corsair Airflow PRO Quick Start Guide
8
Connect the power cable to an available 4-pin molex adapter from your
power supply.
9
Power on your system and enjoy the show!
Corsair Airflow PRO Quick Start Guide
Resources
Corsair Airflow PRO Product Page:
http://www.corsair.com/products/airflowpro/default.aspx
© June,, 2010, Corsair Memory, Incorporated. All rights reserved. All trademarks and registered
trademarks are the property of their respective owners in the United States and/or other countries.
/
