© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Rev. 5
7/1/2021
LPH Harness Instruction Guide
®
Example Installation - 4-Channel Amplier - (HARNESS CUT REQUIRED)
Example Installation - Mono Amplier - (HARNESS CUT NOT REQUIRED)
RCA FROM LPA
"CUT HERE
AND INSULATE"
• Cut the harness close as possible to the
"CUT HERE AND INSULATE" label. You
must insulate wires to prevent damage to
OEM radio.
• The cut speaker wires will need to be
connected to your aftermarket amplier.
(REFER TO LABEL ON HARNESS)
• Please refer to the chart on the rst page
for wiring your loose wires to your LPA.
• This harness is designed to work on OEM
NON-AMPLIFIED systems.
OEM RADIO HARNESS
LPH TO RADIO CONNECTION
LOOSE WIRES TO LPA
REM OUT FROM LPA
DO NOT CUT!!
• If using a 2-Channel input LPA
use the front speaker wires
and insulate the remaining front
speaker wires.
• DO NOT CUT the speaker wires
inbetween the "CUT HERE"
Lables in order to keep the
factory speakers functional.
• This harness is designed to
work on OEM NON-AMPLIFIED
systems.
OEM RADIO HARNESS
LOOSE WIRES TO LPA
"CUT HERE AND
INSULATE"
"CUT HERE AND CONNECT TO
AFTERMARKET AMPLIFIER"
LPH TO RADIO CONNECTION
RCA FROM LPA
REM OUT FROM LPA
AFTERMARKET AMPLIFIER
AFTERMARKET AMPLIFIER
"CUT HERE AND CONNECT TO
AFTERMARKET AMPLIFIER"
(CUT SPEAKER WIRES)