Signature Hardware Hardesty Thermostatic Shower Set Installation guide
- Category
- Faucets
- Type
- Installation guide
1Hardesty Shower Set Installation Instructions
HARDESTY THERMOSTATIC SHOWER SET
INSTALLATION INSTRUCTIONS
Before installing, read entire shower set installation instructions. Observe all local building and safety codes.
For the following installation instructions for your new shower set it is assumed that the water supply lines are in place
behind the nished wall and are directly accessible for installation.
Unpack and inspect shower system for any shipping damages. If you nd any damages, do not install. Contact
Customer Service at 1-866-855-2284. If you need assistance while installing your shower set, call our Customer Service
number.
We recommend consulting a professional if you are unfamiliar with installing bathroom xtures and plumbing. Signature
Hardware accepts no liability for any damages to the oor, walls, plumbing or personal injury during installation.
INSTALLATION
1. Install the valve body as shown in the installation diagram (pg. 2). Wrap the threaded portion of the joints in Teon tape
and connect the water inlet and outlet. Make sure that hot water pipe is on the left and the cold water pipe is on the
right. The distance between pipe center and nished wall is 1"-2". Important: Flush the water supply pipes to remove
any dirt or debris before installing the valve body.
2. Plug the shower inlet and the spout inlet. Turn on the water supply and open the cartridge. Make sure that no leakage
occurs. Note: Because the shower system has a built-in valve, test the water pressure after the pipe connections have
been made and before the nished wall material is installed.
3. Put the protective cover on the valve body and nish the shower wall.
4. When the nished wall is complete, remove the protective cover and install the escutcheon. Install the handle and
tighten with the M5 screw. Insert the plug.
5. Attach the shower arm escutcheon to the shower arm. Wrap the threaded portion of the shower arm with Teon tape
and connect it to the shower inlet. Adjust the direction of the water ow as needed. Attach the rainfall shower head to
the shower arm.
6. Turn on the water supply and open the faucet valves. Check for any leaks and verify that the hot and cold supplies
are working correctly. Let the water ow through the riser pipe for approximately 30 seconds to clear out debris and
dirt.
2Hardesty Shower Set Installation Instructions
82-1/2"
Thermostatic Cartridge
Filter Net
Slot
Lock Sleeve
Slot Mark
Small Filter Net
End Cap
Stop Collar
Handwheel
Locking Screw
Escutcheon
2.5mm Wrench
Rubber Sleeve
Pliers
Set Screw
Handle
Handle-body
Shower Arm Escutcheon
Shower Arm
Rain Shower
Stop Valve
Thermostatic Cartridge
Expansion Pipe
Pilot Hole
Self-tapping Screw
H
ot
Water
Inlet
End Cap
Set Screw
Rubber Sleeve
Handle
Pliers
Escutcheon
Cold
Water Inlet
Escutcheon
INSTALLATION DIAGRAM
MAINTENANCE DIAGRAM
1"-2"
Diverter
(back)
All product dimensions are nominal.
OUT
HOT WATER
IN
COLD WATER
IN
-
1
-
2
-
3
Signature Hardware Hardesty Thermostatic Shower Set Installation guide
- Category
- Faucets
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Aquasana AQ-2100W Installation guide
-
Speakman SM-5070 Installation guide
-
-
-
-
-
-
-
Delta Faucet T17282-SS Installation guide
-
Delta T17494-CZ-I Installation guide