Rejuvenation ELKTON Assembly Instructions Manual

Brand: Rejuvenation

Model: ELKTON

Type: Assembly Instructions Manual

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

1/8

KTON DOUBLE SINK VANITY

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

2/8

BEFOREYOUBEGIN

 Marbletopisbothheavy,anduntilinstalled,fragile.Pleasehaveahelperandusecautionwhenmovingmarble

top.

 Makesuretoobservealllocalplumbingcodes.

 Priortoinstallation,unpackandinspectboththeconsoleandmarbletopandporcelainla vatoryfordamage.

Locat

etheinstallationpartspackageandputinasafeplace—youwillneedthisforinstallation.

 Donotdisposeofanypackagingorcontentsoftheshippingcartonuntilassemblyiscompletedtoavoidaccidentally

discardingsmallpartsorhardware

 Inst

allationassumesthatwallsandfloorareplumbandlevel.Pleasemakeappropriateadjustmentsforother

conditions.

 Removeanymoldingthatmaypr eventtheconsolefrombeingsetflushtothefinishedwall.

TOOLSANDMATERIALS

 Tapemeasure

 Pencil

 Level

 Drillwithappropriatedrillanddr

iverbit

 Eyeprotection

 Clear100%siliconeadhesivecaulk

 Woodscrews(forsecuringconsoletowoodframing)

CAREINSTRUCTIONS

 Dustoftenusingaclean,soft,dryandlint‐freecloth.

 Immediatelyblotupspills,thenwipewithaclean,dampcloth.

 Wedonotrecommendth

euseofchemicalcleansers,abrasivesorfurniturepolishonourlacqueredfinish.

 Hardwaremayloosenovertime.Periodicallychecktomakesureallconnectionsaretight.Re‐tightenifnecessary.

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

3/8

∅8 x 2 3/4" – 4x

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

4/8

TEST FIT THE VANITY BASE

• Remove the drawer:

1. Pull open the drawer.

2. Remove the 4 screws on the underside of the drawer that attach drawer slide to the

drawer .

3. Lift up the front of the drawer an inch and pull forward to disengage the tabs at the

back of the drawer.

4. Set aside in a safe place and push the drawer slides back into the vanity.

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

5/8

TEST

FIT THE VANITY BASE (cont’d)

 Positi

on the vanity base in the desired location against the finished wall.

 Verify that the vanity base is level: front to back and side to side. Adjust the levelers at the

bottom of the legs as necessary.

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

6/8

INSTALL THE VANITY BASE AND MARBLE TOP

• Locate two wall studs to secure the vanity base. Mark these locations on the back rail

of the vanity base. Drill pilot holes through the back rail and into the studs. If necessary

provide shims between vanity and back rail so the back rail is not distorted.

• Using wood screws, secure the vanity to the wall.

• Apply a bead of clear 100% silicone adhesive caulk around perimeter of console top.

• With the help of an assistant, carefully lift the marble top into position. Check carefully

for fit and alignment.

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

7/8

INSTALL THE SINK AND FAUCET

• Temporarily position the sinks over the cutout and make sure that it is aligned properly.

• Apply several pieces of blue painters tape on both the countertop and sink. Make marks

on tape as an alignment guide for final installation.

• Referring to the faucet manufacturer’s instructions, install the drain and faucet

assemblies onto the sink.

• Turn the sinks on one side and apply a small bead of clear 100% silicone adhesive caulk

around the bottom edge of the sink.

• Holding t

he sinks slightly above the desired location, aligning it with the guide marks.

Gently

lower the sink into place. Carefully check placement and alignment.

• Press

down on sinks to ensure a tight seal. Let the sealant set, as stated in the silicone

adhesive c

aulking label’s instructions.

• Connect the supply lines and drain pipes.

Assembly instructions

Instructions d’assemblage

Instrucciones de Ensamblaje

2018.03.20

www.rejuvenation.com

8/8

REINSTALL THE DRAWER

1. Extend the drawer slides and note the alignment hook on the back of each slide.

2. Note the

notched holes at the back of the drawer.

3. Set the drawer onto the slides so that the drawer slide hook fit into the notches.

4. Reinstall the 4 screws on the underside of the drawer that attach drawer slide to

the drawer sides.

Rejuvenation ELKTON Assembly Instructions Manual

Brand: Rejuvenation

Model: ELKTON

Type: Assembly Instructions Manual

Download PDF

report

Rejuvenation ELKTON Assembly Instructions Manual

Rejuvenation ELKTON Assembly Instructions Manual

Other documents