Solac VT8860 Owner's manual

Page is loading ...

Libro VT8860.book Page 1 Friday, February 23, 2007 3:19 PM

Libro VT8860.book Page 2 Friday, February 23, 2007 3:19 PM

Page is loading ...

8 IMPORTANT

ENGLISH en

1IMPORTANT

• Read these instructions carefully before using the appliance and keep

them handy for future reference.

• Check that the voltage on the specifications plate matches the mains

voltage in your home.

• Remove all paper or plastic bags, plastic sheets, cardboard and labels

inside or outside of the appliance, which have been used to protect the

appliance during transport or during the sale promotion.

• Do not insert any object inside the grille.

• Never immerse the appliance in water or any other liquid. Do not put it

near a bathtub, shower or swimming pool.

• While in use, the appliance must be out of the reach of children, animals

and disabled persons. If the appliance is used in their presence, keep a

watchful eye on such operations.

• The appliance is destined solely for home use; it may not be used for

industrial purposes.

• Do not use the appliance if it does not work properly or if the power cable

is damaged; take it to a Specialised Technical Service Centre.

• Keep the appliance at least 50cm from any other object.

• Before turning on the appliance, check that it is on a stable surface and

placed on its base.

B WARNING!!: When you wish to dispose of the appliance, NEVER

throw it in the rubbish bin. Instead, go your nearest CLEAN POINT or

waste-collection point, where it will receive subsequent treatment.

You will thus be helping to take care of the environment.

2 MAIN COMPONENTS

1. Carry handle

2. Grille

3. Blades

4. Electrical current selector

5. Speed selector

6. Charge indicator light

7. Power indicator light

Libro VT8860.book Page 8 Friday, February 23, 2007 3:19 PM

CHARGING THE BATTERY 9

en

8. Swing selector

9. Cord holder

10. Battery access door

3 CHARGING THE BATTERY

 Charge the appliance before using it for the first time. (Charging is not

necessary if the appliance is used while connected to the mains)

 Recharge the appliance after use and make sure that the 0 position is

selected while not in use.

1 To charge the battery, connect the appliance to the mains, select the DC

position on the electrical current selector (4) and the 0 position on the

speed selector (5). The charge indicator light comes on to confirm that

the appliance is charging (Fig. 1).

2 Maximum charge is obtained after approximately 20-24 hours of

charging. Once the appliance is charged, it will run for 3 to 5 hours

depending on whether it is used at maximum speed or not (lower

autonomy at higher speeds). The autonomy may last longer than 6 hours

if you select the slowest speed and the swing function is not used.

4 OPERATION

1 When using the appliance connected to the mains, select the AC option

on the electrical current selector (4) and options 1 or 2 on the speed

selector (5) depending on the air flow preferred.

2 When using the appliance while it is not connected to the mains, select

the DC option on the electrical current selector (4) and options 1 or 2 on

the speed selector (5) depending on the air flow preferred.

3 To select the swing function, push the swing selector (8) to the left (Fig.

2). To stop the swing function, push the swing selector (8) to the right.

5 CHANGING THE BATTERY

• Unscrew the 4 screws on the battery access door (10), remove the

battery and replace it with a new 6V4.5AH battery. Screw on the battery

access door again.

6 CLEANING AND MAINTENANCE

 Your appliance must be disconnected from the mains before any

cleaning operation is performed. As well as disconnecting the appliance

from the mains, make sure that the appliance is set at 0.

Libro VT8860.book Page 9 Friday, February 23, 2007 3:19 PM

10 CLEANING AND MAINTENANCE

• Clean it with a slightly damp cloth. When cleaning the blades, unscrew

the screw that fixes both grilles and tighten it again after the cleaning

operation has been carried out. (Fig. 3).

• Do not use solvents or abrasive cleaners to clean the device, since they

could damage its plastic parts.

Libro VT8860.book Page 10 Friday, February 23, 2007 3:19 PM

Page is loading ...

Libro VT8860.book Page 1 Friday, February 23, 2007 3:19 PM

Libro VT8860.book Page 3 Friday, February 23, 2007 3:19 PM

Libro VT8860.book Page 4 Friday, February 23, 2007 3:19 PM

Solac VT8860 Owner's manual

Solac VT8860 Owner's manual

in other languages

Related papers

Other documents