Important Safety Instructions
SAVE THESE INSTRUCTIONS.
DANGER:
DANGER:
DANGER:
WARNING:
CAUTION:
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
Wire Size AWG
SAVE THESE INSTRUCTIONS
SYMBOLS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V .................. volts A ...................amperes
Hz ................ hertz W ..................watts
min .............. minutes
or AC .......alternating current
or DC ... direct current
n
o..................no load speed
................ Class I Construction ..................earthing terminal
(grounded)
.................safety alert symbol
................ Class II Construction .../min or rpm...revolutions or
(double insulated) reciprocation per minute
Introduction
Charging Procedure
(Fig.1) Be sure the pack is fully
seated in the charger. -
Charge Indicators
Replace Pack:
red light flashing at a fast rate.
Wall Mounting (Figure 2)
Leaving the Battery Pack in the Charger
NOTE:
Important Charging Notes
NOTE:
-
THE RBRC™ SEAL
1-800-8-BATTERY.
Important
READ ALL OF THE INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO
CHARGE THE BATTERY PACK FOR YOUR TOOL.
VEA EL ESPANOL EN LA CONTRAPORTADA.
ADVERTENCIA:
INSTRUCTION MANUAL
FAST CHARGER
Save thiS inStruction Manual for future reference.
Catalog No. BDCCN24
Thank you for choosing Black & Decker!
Go to www.BlackandDecker.com/NewOwner
to register your new product.
PLEASE READ BEFORE RETURNING THIS
PRODUCT FOR ANY REASON:
HTTP://WWW.BLACKANDDECKER.COM/INSTANTANSWERS
SAFETY GUIDELINES - DEFINITIONS
DANGER:
WARNING:
CAUTION:
NOTICE: