Glacier Bay HD67416-3704 Installation guide

Category
Sanitary ware
Type
Installation guide

This manual is also suitable for

THANK YOU
USE AND CARE GUIDE
TWO-HANDLE ROMAN TUB FAUCET
Questions, problems, missing parts? Before returning to the store,
call Glacier Bay Customer Service
8 a.m. - 6 p.m., EST, Monday - Friday
1-855-HD-GLACIER
HOMEDEPOT.COM
Model #67416-3701
67416-3704
faucet. We strive to continually create quality products designed to enhance your home. Visit us online to see
our full line of products available for your home improvement needs. Thank you for choosing Glacier Bay!
REV.02YOW
2
Table of Contents
Safety Information ....................................2
Warranty ...................................................2
Pre-Installation .........................................3
Planning Installation ..............................3
Tools Required .......................................3
Hardware Included .................................3
Package Contents ..................................4
Installation ................................................5
Operation...................................................8
Care and Cleaning ....................................8
Service Parts
...........................................
9
Safety Information
Please read and understand this entire manual before
attempting to assemble, operate, or install the product.
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Warranty
LIMITED LIFETIME WARRANTY
Glacier Bay products are manufactured with superior quality standards and workmanship and are backed by our
limited lifetime warranty. Glacier Bay products are warranted to the original consumer purchaser to be free of
defects in materials or workmanship. We will replace FREE OF CHARGE any product or parts that proves defective.
Simply, return the product / part to any of The Home Depot retail locations or call 1-855-HD-GLACIER (1-855-434-
5224) to receive the replacement item. Proof of purchase (original sales receipt) from the original consumer
purchaser must be made available for all Glacier Bay warranty claims.
This warranty excludes incidental/inconsequential damages and failures due to misuse, abuse or normal wear and
tear. This warranty excludes all industrial, commercial & business usage, whose purchasers are hereby, extended
duration of warranty.
Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations may not apply to you. This warranty gives you specic legal rights and you may also have other
rights that vary from state to state and province to province. Please see a store or contact 1-855-HD-GLACIER for
more details.
3 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Pre-Installation
PLANNING INSTALLATION
Before beginning the installation of this product, ensure all parts are present. Compare parts with the Package
Contents and Hardware Included list. If any part is missing or damaged, do not attempt to install the product.
TOOLS REQUIRED
Adjustable
wrench
Safety
goggles
HARDWARE INCLUDED
NOTE: Hardware not shown to actual size.
AA
Part Description Quantity
AA 1Hex wrench
Basin wrench
4
Pre-Installation (continued)
PACKAGE CONTENTS
Part Description Quantity
A 1
B Set screw 1
C Index 1
Spout assembly
D 1
E Middle body 1
F Rubber washer 1
Connector
G 1
H Nut 1
Metal washer
I 2Handle
J 2Flange
K 1Hot end valve
L 1Cold end valve
M 2Rubber washer
N 2Metal washer
O 2Mounting nut
P 2Hose
Part Description Quantity
A
B
C
D
F
G
H
E
I
J
L
M
N
K
O
P
5 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Installation
Preparing for installation
1
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Drill 1-3/8 in. holes in the nished deck as
shown in the diagram below.
2
Installing the middle body
From underneath the deck, insert the middle
body (E) with the rubber washer (F), metal
washer (G) and nut (H) through the mounting
hole.
From above, thread the connector (D) onto the
middle body (E).
NOTE: This kit allows up to 1-1/4 in. deck thickness.
5 in. min.
1-3/8 in.
1-1/8 in.
1-1/4 in. MAX DECK THICKNESS
8~16 in.
3 in. min.
Tighten the nut (H) using a basin wrench, so that
the connector (D) sits ush against the nished
deck surface.
H
G
F
E
D
6
Installation (continued)
3
Installing the spout assembly
Install the spout assembly (A) onto the
connector (D). Be sure the spout assembly
is resting rmly on the deck.
Push down on spout and tighten set screw (B)
with the Hex wrench (AA). Insert the index (C).
4
Installing the hot and cold
valves and handle assemblies
D
A
AA
C
B
Thread the handle (I) onto the ange (J).
Repeat this procedure for the hot end valve (K)
on the left (hot) side.
From underneath the deck, insert the cold end
valve (L) with the rubber washer (M), metal
washer (N), and mounting nut (O) through the
hole on the right (cold) side.
From above, thread the ange (J) onto the valve.
Tighten the mounting nut (O) using a basin
wrench, so that the ange (J) sits ush against
the nished deck surface.
NOTE: After install handle assembly, if the handle seat is
not aligned with handle in a line as shown in the
above diagram (2), rotate the handle seat back (the
ratating angle can not exceed 90°) to make the
handle seat align with handle in a line.
K
1
L
O
N
M
I
2
J
7 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
5
Making the waterline
connections
Connect the water supply lines (1) to the faucet
inlets (2). (Supply lines are not included.)
6
Connecting the hoses
Connect the hoses (P) to the bottom of the hot
and cold end valves (K & L), as shown.
Align the middle body (E) in a position that will
allow maximum clearance to connect the
hoses (P).
Carefully bend the hoses (P) to t in the available
space, and carefully thread the hose (P) couplings
onto the sides of the middle body (E). Tighten all
connections with a wrench.
2
2
1
1
P
K
L
E
8
Care and Cleaning
Do not use abrasive cleaners when cleaning this faucet.
1
Flushing and checking for leaks
Turn on the water supply and allow both hot
and cold water to run for at least one minute
each. This ushes away any debris that could
cause damage to internal parts.
While the water is running, check for leaks.
Turn off the water.
Operation
9 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Service Parts
*Specify Finish
Part Description Part Number
1
2
3
Handle RP13322*
4
5
Flange RP70439
6
Bonnet RP70001
7
Cartridge (H) RP20035
8
Cartridge (C) RP20036
9
Rubber washer
RP64023
Aerator RP30036
16 Nut RP56088
17 Hex wrench RP70332
18 Hose RP70042
Part Description Part Number
Metal washer RP64024
Mounting nut RP56014
10 Set screw RP50054
11 Index RP10067*
12 O-ring RP60056
13 O-ring RP60094
14 Rubber washer RP64035
15 Metal washer RP64036
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
18
17
Questions, problems, missing parts? Before returning to the store,
call Glacier Bay Customer Service
8 a.m. - 6 p.m., EST, Monday - Friday
1-855-HD-GLACIER
HOMEDEPOT.COM
Retain this manual for future use.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30

Glacier Bay HD67416-3704 Installation guide

Category
Sanitary ware
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI