10 Topcom Babytalker 2500
Topcom Babytalker 2500
5.9 Sound alert
The babies voice detection level is indicated by the number of volume indicator LED’s (1) on
top of the display. Only when the volume of the parent unit is set to ‘Off’, a beep can inform
you when the voice level reached the red led zone.
• Press (8) on the parent unit, ‘Night Light’ is displayed.
• Press (11) until ‘Sound alert’ is displayed.
• Press (4). ‘On?’ is displayed.
• Press (4) to confim.
• Press (11) or (10) to select the sound level of the beep tone.
• Press (4) to confirm.
• Press (8) to leave the menu.
To deactivate the Sound alert, follow the same instructions, but select ‘Off?’.
6 Registration
When the baby unit night lights are flashing and/or no communication can be established
between the baby- and parent unit (the green link LED on the parent unit will flash), the parent
unit needs to be registrated to the baby unit.
6.1 Registration
• When baby unit is in power off state, press and hold the On/Off button on the baby unit,
while connecting the power adaptor.
• The baby unit will power on and enter registration mode.
• Release the On/Off button. Under baby unit registration mode, the night light will flash
for 60 seconds.
• During registration mode, press and hold the On/Off button on the parent unit while
inserting charged batteries.
• The parent unit will power on and 3 red volume indicator LED’s will flash.
• If the registration is success, the baby unit night light will stop flashing and exit
registration mode.
• The 3 red volume indicator LED’s on the parent unit will go out and exit registration
mode with confirmation tone (1 long beep).
• If the registration is unsuccesful or the registration mode time is elapsed, the baby unit
night light will stop flashing and exit registration mode.
• The 3 red volume indicator LED’s on the parent unit indication will go out and exit
registration mode with an error tone (3 short beeps).
• Retry the procedure.
To verify the linkage between parent unit and baby unit:
• Pressing the paging button on the baby unit for 2 seconds.
• The parent unit will emit a high beep tone for 30 seconds.
• Press any button on the parent unit briefly to stop the beep.