OWNER’S MANUAL
OMĆ698C 189 244C
October 2000
Running Gear/Cylinder Rack (043 796)
WARNING
ELECTRIC SHOCK can kill.
• Do not touch live electrical parts.
• Turn Off welding power source and input disconnect
device.
• Disconnect input plug or power conductors from
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
• Keep cylinders away from welding and other
electrical circuits.
• Never touch cylinder with welding electrode.
• Always secure cylinder to running gear, wall, or
other stationary support.
FALLING EQUIPMENT can cause injury
and damage, OVERSIZED CYLINDER
can cause tipping.
• Move unit with proper handcart.
• If using a fork lift vehicle, secure unit on a skid.
• Never lift unit with cylinder attached.
• Maximum cylinder weight is 100 lb (45 kg).
802 051-A / Ref. 802 052
Tools Needed:
1/4, 3/8, 7/16, 1/2 in
Description (Qty)
Part
No.
Item
No.
1 189 041 Handle (1)
2 152 461 Nut, 250-20, wshr (2)
3 189 042 Pan, Base (1)
4 189 045 Tray, Pan (1)
5 602 154 Screw, 1/4-20 x .50 (6)
6 189 043 Support, Back (1)
7 137 653 Label, Warning (1)
8 602 387 Chain (1)
9 189 046 Tray, Bottle (1)
10 189 040 Axle (1)
11 090 693 Wheel, 8 in (2)
12 602 250 Washer, .812 ID flat (2)
13 121 614 Retaining Ring (2)
14 189 044 Pan Tray (1)
15 049 966 Screw, 1/4-20 x 1.50 (4)
16 192 097 Caster, 4 in (2)
Be sure to provide Model when ordering
replacement parts.
. It is recommended that the welder be
secured so that it cannot fall off the
cart. Holes are provided in the base
pan (3) for use when tying down the
welder.
1
2
3
4
5
6
7
8
9
10
11
12
13
5
14
15
16
Figure 1. Installing Running Gear/Cylinder Rack
/
