2. Shark
  3. UV700

Shark UV700 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Shark UV700 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
UV700
Performance Lift-Away
®
Upright Vacuum
QUICK
START
GUIDE
Use this Quick Start Guide
to learn about your new
vacuum’s great features.
Please be sure to read the enclosed Shark® Owner's Guide prior to using your unit.
A
Vacuum Pod
B
Motorized Floor Nozzle
C
Handle & Hose
D
Wand
E
Pet Multi-Tool
F
Duster Crevice Tool
E
F
Attach onboard
accessories
OR
WHAT’S INSIDE:
For additional parts and accessories,
visit sharkaccessories.com
For complete maintenance instructions,
see the enclosed Owner's Guide.
(Click)
(Click)
(Click)
1
(Click)
ASSEM B LY
A
C
D
B
1. Attach vacuum pod to floor nozzle.
2. Insert wand into pod.
3. Insert handle and hose into wand.
4. Press hose into back of pod.
2
3
4
Add desired
cleaning accessory
2 WAYS TO CLEAN:
1
UPRIGHT
2
LIFT-AWAY
Carpet
Hard Floor
Carpet
Hard Floor
Lift-Away
Release
OR
Handle
Release
Wand
Release
Suction
Control
Power
Press the Power/Surface
Selector button to turn the
vacuum on or o.
Floor Setting
Slide the Power/Surface
Selector button up or down
to choose floor type.
MAINTENANCE
To register your product, or for answers to frequently asked questions, visit registeryourshark.com.
©2018 SharkNinja Operating LLC. SHARK is a registered trademark of SharkNinja Operating LLC.
To open the brushroll garage, slide both release buttons on the floor nozzle away from you, towards the
back of the nozzle, then lift o the lid. Clear away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down on
both sides of lid until it clicks securely into place.
CLEANING THE BRUSHROLL
Zero-M™ Technology
Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum. If you run
over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
TECHNOLOGY
WITH
™
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M™ technology to remove it for you. If
some fibers remain wrapped around brushroll after continued use, carefully cut debris with scissors and remove from brushroll.
To remove the Soft Roller from the nozzle, lift it out by
the pull tab. Tap loose debris o the Soft Roller. Use a
dry towel to wipe the Soft Roller clean, or to remove
any debris caught in the teeth behind the Soft Roller.
Hand wash the Soft Roller as needed. Use only
water, and let air-dry completely for at least
24 hours. Reinsert the Soft Roller under the rubber
bumper in the front of the nozzle until it clicks into place.
CLEANING THE SOFT ROLLER
/