Dacor AGDRT12 User guide

Category
Barbecues & grills
Type
User guide

Dacor AGDRT12 is a grill that can be placed on top of select Dacor cooktops and ranges. It features a non-stick coating for easy cleaning and is designed to be used over two burners, with the grease trap positioned towards the back. The grill should only be placed in the position shown in the instructions and the burners underneath should not be turned higher than the "MAX GRIDDLE" setting to prevent damage. Before using the grill for the first time, it should be washed in hot soapy water and allowed to dry thoroughly.

Dacor AGDRT12 is a grill that can be placed on top of select Dacor cooktops and ranges. It features a non-stick coating for easy cleaning and is designed to be used over two burners, with the grease trap positioned towards the back. The grill should only be placed in the position shown in the instructions and the burners underneath should not be turned higher than the "MAX GRIDDLE" setting to prevent damage. Before using the grill for the first time, it should be washed in hot soapy water and allowed to dry thoroughly.

Grill Placement and Use
Grill Models: AGDRT12 and AGRG12
INSTRUCTIONS
Cooktop/Range Models: DRT366S, ER36G and ER36GI
Part No. 106558 Rev. D
WARNING: Do not touch the grill when hot.
WARNING: Do not use water on grease res. A violent steam explosion may result. Smother any
ames with a lid, cookie sheet or at tray. Use baking soda or a foam extinguisher to extinguish am-
ing grease. Be careful to avoid getting burned.
WARNING: This grill has a non-stick coating. Non-stick coatings, when heated, can be harmful to
birds. Remove birds to a separate, well-ventilated room during cooking.
CAUTION: This grill kit comes with two extra knobs marked with the words MAX GRIDDLE. They
must be installed according to these instructions before use to prevent damage to the grill.
CAUTION: Place the grill only in the position shown in these instructions. Do not turn the burners un-
der the grill higher than the MAX GRIDDLE setting. Setting the burner ames too high or putting the
grill in the wrong position may damage it permanently.
Before using the griddle for the first time...
STEP 1 Decide which side of the cooktop/range you want to use the griddle on. Remove the two knobs on the far
right or the far left of the control panel based on the side the griddle will be used. Leave all other knobs in
place.
NOTE: If you have difculty removing any of the knobs, a rubber grip (strip) is included with the kit. To use,
peel the protective backing off of the rubber strip and wrap the adhesive side around the knob as shown.
The grip can be peeled off and reapplied to the other knobs.
Initial Set Up
Knob Grip Installation
continued...
Grill Placement and Use
Page 2
STEP 2 Put the new knobs from the kit, with the words MAX GRIDDLE on them, on the valve shafts in place of
the knobs removed in step 1. The knob with the shortest space between the ame icon and the simmer
icon goes on the valve stem for the standard burner A . The other knob installs on the valve stem for the
SimmerSear (dual) burner B . When installing the knobs, align the “D-shaped” opening on the back of
the knob with the end of the valve shaft. Carefully push the knob on until it stops. The old knobs may be
discarded.
Initial Set Up (continued)
A
A
B
B
or
ER36G and ER36GI RangeDRT366S Cooktop
A
A
B
B
or
B New SimmerSear (dual) burner knob with wide space
between icons
A New standard burner knob with short space between icons
STEP 3 Wash the griddle in hot soapy water. Rinse it and allow it to dry thoroughly.
Grill Placement and Use
Page 3
Instructions for Use
STEP 1 Make sure all burners are off and the cooktop/range is cool to the touch. Put the
grill over the top of the grate on the side of the appliance with the knobs that have
the MAX GRIDDLE icons. The grease trap goes toward the back. Fit the tabs that
stick out of the bottom of the feet into the inside corners of the grate. When correctly
installed, the grill will rest securely about 1/2” above the top surface of the grate. It
may rock back and forth slightly, which is normal.
STEP 2 Set one of the burners under the grill to the light (high) position.
Once lit, immediately turn the knob to the MAX GRIDDLE position,
or lower if desired. DO NOT keep the burner knobs higher than the
MAX GRIDDLE setting after they are lit!
STEP 3 Repeat step 2 for the other burner under the grill.
STEP 4 During cooking be careful with metal utensils on the surface
because they can scratch the non-stick coating. See below for cleaning instructions.
After each use, wash the grill thoroughly in hot soapy water to avoid stains from grease build-up. The grill is coated
with a non-stick coating for easy cleaning. Warm water and liquid detergent are all that are needed for cleaning.
Remove stubborn spots with a non-abrasive plastic mesh pad. To prevent scratching, do not use abrasives or
abrasive cleaners.
Cleaning the Grill
Line up bottom
of grill with top
of grate
ER36G and ER36GI Range DRT366S Cooktop
Grease trap
toward back
or
Put over left or right burners
(not center burners)
Grease trap toward back
Put over left or right burners
(not center burners)
or
Line up bottom
of grill with top
of grate
Light position
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Dacor AGDRT12 User guide

Category
Barbecues & grills
Type
User guide

Dacor AGDRT12 is a grill that can be placed on top of select Dacor cooktops and ranges. It features a non-stick coating for easy cleaning and is designed to be used over two burners, with the grease trap positioned towards the back. The grill should only be placed in the position shown in the instructions and the burners underneath should not be turned higher than the "MAX GRIDDLE" setting to prevent damage. Before using the grill for the first time, it should be washed in hot soapy water and allowed to dry thoroughly.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI