• Always use a larger screw and wall plug if you are not sure.
• Ensure you use the recommended drill bit to match the wall plug and hole size.
• Ensure you drill the hole horizontally, do not force the drill or enlarge the hole.
• Take extra care when drilling high walls and ceramic tiles. Ensure wall plugs are inserted beyond the
thickness of the ceramic tiles to avoid the tiles splitting or cracking.
• Ensure wall plugs are well tted and are a tight t in the drilled hole.
• To prevent debris getting behind the splashback, we recommend the sides are sealed using wall tiles or a
suitable silicone sealant.
Installation
1. Carefully remove all packaging materials including the protective sheet. You may use a soft damp cloth to clean the surface
and the edge of the splashback after removing the protective sheet.
2. Ensure that the surface of the wall is at, and free of dust and dirt.
3. Place the splashback on the wall and mark the wall with a pencil through the holes in the splashback.
4. Drill 3 holes (hole dimension Ø8 x 45 mm) into the wall according to the diagrams below.
Care & Maintenance
• Your splashback should be cleaned regularly using a
proprietary cleaner.
• Never use any sharp instruments or abrasive substances,
soap, detergent or wax polish for cleaning.
L60SPLX10 L90SPLX10
2 people are required to lift the unit during assembly, it is recommended that gloves are worn.
· Before drilling holes check
that the wall is clear of any
cables, pipes etc.
· Make sure that the screws
and wall plugs being used
are suitable for supporting
your unit. Consult a qualied
technican if you are unsure.
5. Use the screws and wall plugs provided to x the splashback.
6. Tighten the screws and press the splashback to the wall.
7. Any gaps between the benchtop and the wall must be sealed to exclude
moisture.
DSG Retail Ltd (co. no. 504877)
1 Portal Way, London, W3 6RS, UK
Visit Partmaster.co.uk today
for the easiest way to buy
electrical spares and
accessories. With over 1 million spares and accessories
available we can deliver direct to your door the very next day.
Visit www.partmaster.co.uk or call 0344 800 3456 (UK
customers only). Calls charged at National Rate.
The symbol on the product or its packaging indicates that
this product must not be disposed of with your other
household waste. Instead, it is your responsibility to
dispose of your waste equipment by handing it over to a
designated collection point for the recycling of waste
electrical and electronic equipment. The separate collection and
recycling of your waste equipment at the time of disposal will help
conserve natural resources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off your waste for
recycling, please contact your local authority, or where you purchased
your product.
IB-L60_90SPLX10-160128V6
For general information about this appliance
and handy hints and tips, please visit
www.knowhow.com/knowledgebank or call 0344 5611234.
L60_90SPLX10_IB_RC_160128_grace.pdf 2 28/1/16 11:36 am