ELECTRONICS
FEATURES:
1. Standard
2. Easy motor direction chang
3. Auto close facility (Infra re uto close is activated).
Condominium / Free exit loop facility
d Access Control) facility
(Ramp down) facility
e
d beams must be fitted if a
4.
5. P.I.R.A.C (Passive Infra Re
6. Slowdown
1. Standard Mode (No function selected)
When the gate is activated it will open and can be stopped in mid cycle by pressing the
itter or push button can reverse the
ain on its open limit until it is triggered to close.
If main power fails, the motor will still operate until battery reaches 20 volt. Gate will then
ng the motor by the override lever. When the
2. Easy motor direction change (Dipsw
transmitter or manual push button. Pressing the transm
gate. In standard mode the gate will rem
remain close. Change to manual by overridi
main power comes on again, lock in the override lever and the motor will function as
normal.
itch 2)
dipswitch, the motor direction and the limit wires By selecting the
are changed
utomatically a
. Dipswitch ON, gate closes to the right. Dipswitch OFF, gate closes to the
Auto close (Dipswitch 3
left.
3. On) (Infra red beams must be fitted if auto close is activated).
open limit, the gate will wait the
If the gate is triggered while the gate is
is in its opening cycle, the
gate will close after the preprogrammed auto close time (from any position, not only from
the open limit)
When Auto close is activated and the Gate opens to the
pre-programmed time before automatically closing.
in its closing cycle it will stop and reopen.
To override the auto close wait till the gate reaches its open limit then press & hold the
transmitter or manual push button for 5 sec. (The control card will give 1 long beep to
9
confirm the override) To reactivate the auto close, press the transmitter or manual push
button.
If the transmitter or manual push button is pressed while the gate
