3
ASSEMBLY STEPS
STEP 1
Place the drilling template (C) on the
underside of the desktop, making sure
the flat side is flush with the edge, and
mark drilling locations with a pencil. Drill
0.6” (15mm) deep holes using a 7/64”
(3mm) drill bit.
STEP 2
Unscrew the knob from the
support post (B).
STEP 3
Making sure the flat side is facing
forward, mount the support post to
the desktop using screws (D).
STEP 4
Snap the cable clip (E) into the back of
the support post. Attach the tray (A) to
the post using the previously removed
knob.
STEP 5
Place mouse on the tray. If the mouse
is wired, use the cable clip to organize
the wire. Swivel the mousepad on top to
open the tray for storage. The tray may
be swiveled underneath the desktop
when not in use.
C
ø 3mm
(ø 3/25")
15mm
(
0.
6”)
B
D
E
+180 °
-180 °
+180 °
-180 °