The IP Endpoint Company
Installation Quick Reference
Speaker Wall Mount for Indoor
Paging Speakers
011152, RAL 9003, Signal White
Quick Reference 930405E © 2020, CyberData Corporation, ALL RIGHTS RESERVED© 2020, CyberData Corporation, ALL RIGHTS RESERVED 930405E Quick Reference
Speaker Wall Mount Parts
Overall Dimensions
(1) Template for Speaker Wall
Mount and Screw Holes*
(1) Speaker Wall Mount
(1) Drywall Mounting Kit
(4) Plastic ribbed anchors(4) #6 x 1.25-inch sheet metal screw
(4) Enclosure mounting screw
(1) Grounding nut
(1) Enclosure to Backplate Mounting Kit
*Note: The drywall mounting kit will be included in
the ceiling speaker kit.
*Install the grounding nut onto
the Backplate’s ground lug.
(3) #8-32 x 0.5 inch Non-Drive Button
Head Machine Screw
(3) #8-32 KEP Nut
(1) Speaker Assembly to Enclosure Mounting Kit
10.4 [264]
Dimensions are in Inches [Millimeter]
4.0 [102]
8°
12.6 [321]
CyberData Part #s: 011394, 011396,
011398, 011400, 011105, 011121
Connecting Power (PoE)
Connecting Power (optional power injector)
Contacting CyberData
Optional Power Injector
(CyberData P/N 011124)
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: (831) 373-2601 ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
4.724 [119.99]
4.000 [101.60]
10.000 [254.00]
8.000 [203.20]
Dimensions are in Inches [Millimeter]
Mounting
Note: Before printing this document or the mounting template, check the following:
Make sure that the Paper Size setting of the printer is set to 11x 17.
Make sure that the Page Scaling setting of the printer is set to NONE.
Connect Network Cable to Speaker Assembly
Step 1
Step 2
Step 5
Step 4
Align Speaker Assembly with
Prepare Hole for Cable Access and
Drill Holes for Plastic Ribbed Anchors
Hang Wall Mount Backplate to Wall,
Wall Mount Enclosure
Secure it with Mounting Screws
Secure it with Non-Drive Button Head
Screws and Nuts
Step 3
Run Network Cable Through Wall & Backplate
or Through Cable Entry on Top
Grounding
Lug
Ground Cable
Nut
Secure it with Mounting Screws on Both Sides
Align Enclosure with Backplate
Step 6
P/N: 121001
Cable Entry
*
*
Cable Entry
P/N: 121010 [RAL 9003]
-
1
-
2
CyberData 011151 - COLOR DISCONTINUED Reference guide
- Type
- Reference guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
CyberData 011152 Reference guide
-
CyberData 011154 Reference guide
-
-
-
-
-
CyberData 011393 - COLOR DISCONTINUED Reference guide
-
-
-