• Do not overtighten the screws. This may damage the threads and reduce the strength of the tting. Check

all screwed ttings occasionally.

• If applicable, route all cables from your device so that they will not be crushed or buckled in the wall

bracket.

• Never overload the product. Pay attention to the information in the "Technical data" section.

• The attachment of the protective ring can prevent possible scratch marks on your device.

• Check the correct t of the protective ring on the wall bracket opening before you insert your device.

• Consult a technician if you are not sure how to use or connect the product.

b) Installation

• In all cases observe the assembly illustrations shown below in the correct order.

• Check the contents of the packaging before assembling the product. Do not assemble the product unless

all components are present.

• Wall-mounting is permissible only where the wall concerned is of the correct type and condition.

• The choice of an unsuitable installation location can lead to personal injury or material damage!

• Plan the installation location carefully, so that the wall bracket is in the desired location (height and

position) after the installation is complete.

• Make sure that the xing location is sufciently stable and rm, in order to support the product and your

device.

• Ensure that no existing cables or pipes (including water pipes) are damaged when drilling mounting holes

or securing screws.

• Look after your own safety when using electric tools (e.g. a drill). Refer to the safety information in the

corresponding instructions.

• In case of doubt, you should not perform the installation yourself. Have an expert carry out the installation.

All rights including translation reserved. Reproduction by any method (e.g. photocopying, microlming, or the capture in

electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.

This publication represents the technical status at the time of printing.

Copyright 2017 by Conrad Electronic SE. *1574816_V1_1017_02_LS_m_en

Amazon Echo optimum protection against being tipped over accidentally by playing children or frolicking

pets. The removable protective ring protects your device from possible scratches.

The product is only intended for dry indoor use.

Read through the installation instructions carefully and store them in a safe place. Only pass on the product

to third parties together with the installation instructions.

This product complies with statutory national and European regulations. All company and product names are

trademarks of their respective owners. All rights reserved.

Delivery content

• Amazon Echo Wall Bracket

• 2x screw

• 2x concrete dowels

• 2x washers

• Protective ring

• Assembly instructions

Current assembly instructions

warranty/guarantee.

a) General information

• The product is not a toy. Keep it out of the reach of children and pets.

• Do not leave packaging material lying around carelessly. This may become dangerous playing material

for children.

• Do not place the product under any mechanical stress.

• Always handle the product carefully. Jolts, impacts or a fall even from a low height may damage the

product.

• Also observe the safety and operating instructions of your Amazon Echo.

1 2 3

5 64