English 2 - 3
Français 4 - 6
Español 7 - 9
instructions
instrucciones
AT503 AT504
HEAD OFFICE: Kenwood Limited, 1-3 Kenwood Business Park, New Lane, Havant, Hampshire PO9 2NH
119699/1
119699 Iss 1 LV AT503-AT504 6 pg multi:Layout 1 24/10/12 08:08 Page 1
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety
precautions should always be followed to reduce
the risk of fire, electrical shock and/or personal
injury including the following:
•
READ ALL INSTRUCTIONS.
•
Close supervision is necessary when any appliance is
used by or near children.
•
Unplug from outlet when not in use and before putting
on or taking off parts and before cleaning.
•
Avoid contacting moving parts.
•
The use of attachments, including canning jars, not
recommended by the manufacturer may cause a risk
of injury to persons.
•
Do not use more than one attachment at a time.
•
Do not use attachment for other than intended use.
•
Never leave your Food Preparation Machine
unattended while it is operating.
•
Keep hands, hair, clothing, as well as spatulas and
other utensils away from beaters during operation to
reduce the risk of injury to persons, and/or damage to
the mixer.
•
Remove beaters from mixer before washing.
•
Refer to your main Kitchen Machine instruction book
for additional safety warnings.
SAVE THESE INSTRUCTIONS
For Household use only
2
English
119699 Iss 1 LV AT503-AT504 6 pg multi:Layout 1 24/10/12 08:08 Page 2
AT503 for use on
Kitchen Machine Chef
AT504 for use on
Kitchen Machine Major
and Cooking Chef
Before using your Kenwood
attachment
●
Remove all packaging.
The flexible beater is designed for
creaming and mixing soft ingredients.
It is not to be used with heavy
recipes such as dough or hard
ingredients, for example those
containing fruit stones, bones or
shells.
1 Carefully fit the flexible wiper blade
onto the tool by locating the base of
the wiper blade into the slot , then
feed one side into the groove before
gently hooking the end in place .
Repeat with the other side .
2 With the mixer switched off, insert
the flexible beater and lower the
mixer head. Check the position of
the beater in the bowl . Ideally it
should be in contact with the bowl
surface so that it gently wipes the
bowl during mixing.
3 If the clearance needs to be
adjusted, raise the mixer head and
remove the beater.
4 Using the spanner provided loosen
the nut sufficiently to allow
adjustment of the shaft . To lower
the beater closer to the bottom of
the bowl, turn the beater shaft
counter-clockwise. To raise the
beater away from the bottom of the
bowl turn the shaft clockwise.
5 Tighten the nut.
6 Fit the beater to the mixer and lower
the mixer head. Check its position
(
see point 2). Repeat the above steps
as necessary until the beater is set
correctly. Once this is achieved
tighten the nut securely.
care and cleaning
1 Always remove the flexible wiper
blade from the tool before cleaning
.
2 Wash the flexible wiper blade and
tool in hot soapy water, then dry
thoroughly. Alternatively the parts can
be washed in a dishwasher.
Note: Please inspect the condition of
the tool body before and after use
and also regularly inspect the
condition of the wiper blade and
replace it if there are any signs of
wear.
●
Any other servicing should be
performed by an authorized service
representative.
3
119699 Iss 1 LV AT503-AT504 Eng_Fre_Sp:Layout 1 24/10/12 08:11 Page 3
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
10
119699 Iss 1 LV AT503-AT504 Eng_Fre_Sp:Layout 1 24/10/12 08:11 Page 10
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Kenwood AT503 Le manuel du propriétaire
- español: Kenwood AT503 El manual del propietario
Related papers
-
Kenwood AT501 Owner's manual
-
Kenwood Electronics KMC577 User manual
-
Kenwood Chef and Major KM630 series Owner's manual
-
-
Kenwood FHM155SI User manual
-
Kenwood CH550 Owner's manual
-
Kenwood Chef and Major KMC010 series Owner's manual
-
-
-