Axema Facia C84 User manual

Facia C84, C88, C86, C87 and C89

Facias are used for flush mounting Axema's readers A66, A63, A61 and A04.

Manual

Updated 2018-10-25

Facia

Facia C84 and C88 fits the flush mount box C83 and BB3

Facia C86 and C87 fits the flush mount boc C85 and BB5

Facia C89 fits the flush mount box TPIM

Facia C84, C88, C86, C87 and C89 1

If A04 or A05 is used. 3

Mounting 4

2 (5)

Manual Facia

If A04 or A05 is used.

1. Supply power the code lock

2. Mount the spacer with the "wing" towards the code lock..

3. The code lock will automatically enter the programming mode.

4. Press A20, enter the desired six digit programming code twice followed by

5. Remove the power, mount the code lock with facia and supply power to the

code lock again.

3 (5)

Manual Facia

Mounting

1. If an existing flush mount box is not available, mount a new box in the wall.

2. Mount the spacer with the "wing" towards the code lock. and the support

plate on the reader insert (the reader without frame and backing. Screw the

insert to the facia using the thumb screws tight enough to hold them in

place, but not harder.

3. Connect the cable to the terminals on the reader.

4. Mount the unit in the flush mount box.

5. Place the rubber strip between the facia and the box.

6. Screw the facia tight using the supplied Secutorx screws.

4 (5)

Manual Facia

Download PDF